Look at attached photo. Hope this helps. 
This picture is not for the application listed.
×
Cam sensor is located behind the front camshaft timing belt sprocket below the power steering pump.
Behind the front camshaft pulley. To access it you remove the timing belt cover, timing belt and the camshaft pulley. https://honda-tech.com/forums/honda-minivans-crossovers-trucks-80/camshaft-position-sensor-location-3242032
SOURCE: Where is the crankshaft position
It is stuck in bellhousing of the transmission near the rear head. The new crank sensor will come with a piece of gasket paper on the end of the sensor. Install the sensor all the way in against the pick-up wheel. When you crank the engine the wheel will rip off the paper and the adjustment will be correct.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: crankshaft position sensor location
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Testimonial: "Awesome. Thanks."
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: crankshaft position sensor location on 2004 chrystler pacifica
can u please tell me where on my 2004 chrysler pacifica is the crankshaft sensor located?
4,440 views
Usually answered in minutes!
It can be removed and replaced without pulling the timing belt and covers with a small 10mm wrench. You can contact me for more info via 6ya for minimal charge.https://www.6ya.com/thericepatch
Do you have a video on how to remove it
×