2006 Chevrolet Avalanche Logo

Related Topics:

renee rodriguez Posted on Feb 10, 2019

My 2006 avalanche run for a few minutes then stop running in all gears. No forward or reverse. Turn it off for about 5 minutes and it will run for a few minutes again. What can cause this

1 Answer

terence watts

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

  • Contributor 6 Answers
  • Posted on Feb 11, 2019
terence watts
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Joined: Feb 13, 2012
Answers
6
Questions
2
Helped
3122
Points
21

Sounds like transmission filter but not sure because not enough details.

Testimonial: "I had the filter replaced already."

5 Related Answers

Anonymous

  • 1990 Answers
  • Posted on Jan 25, 2009

SOURCE: Car just stopped (sudden stop) when it's running on the road.

You will need to Change the Fuel Pump and Fuel Filter and Also Check the Belt Tension. If it is even a little loose it will not Charge the Battery and could cause this problem also. Let me know what you find.

Ad

Jack Hunter

  • 139 Answers
  • Posted on Jul 05, 2009

SOURCE: transmission problems

One of the solenoids in the transmission is acting up go to a transmission shop and have them code the transmission. Some repair shops can also check your transmission if they have the right Diagnostic tool.

Anonymous

  • 4669 Answers
  • Posted on Aug 16, 2009

SOURCE: automatic transmission wont go to first gear

You have checked the fluid. It's full?

Anonymous

  • 9 Answers
  • Posted on Sep 29, 2009

SOURCE: 2006 Mercedes-Benz CLK 350. Sometimes runs to

Check the pole/cord going to your gas pedel..u may have to take up the carpet.. but it could be a bearing in the pedel..

Anonymous

  • 1 Answer
  • Posted on Jan 18, 2013

SOURCE: 1991 Caprice No reverse. Moves in neutral. All forward gears OK.

This is Ron out of Vero Beach Florida. I have been doing trannys for years. The problem you described is caused (more than likely) by a seized clutch pack. Depending on the trans, and your car should be RWD with a 700r4 tranny, there are several sets of clutch packs and at least one band. Automatic transmissions rely on fluid pressure to "engage" the correct set of clutch discs, at the right time , to engage and change gears. I have seen in the past, where a customer parks his car for the evening and the next morning, no move. What happened?? More than likely, a clutch pack was on it\'s way out but cause the car was hot the plates were free, but after cooling, they can weld themselves together and actually "lock-up". In the morning you know the end result. Your tip on "moves in Nuetral" is the give away. Ron

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Transmission will only run in reverse

Sounds like the torque converter, pump are working. It must be the clutch pack for the forward gears if all the linkage is still ok.
0helpful
1answer

Runs good shut off for a few minutes restart runs terrible engine spits and sputters

A bad fuel pump may cause a 2001 Dodge Ram 1500 5.9l to run for a few minutes and just shut off without sputtering. It can also be that the fuel pressure regulator (on top of fuel pump assembly) is stopped up. Dodge Ram trucks have been named Motor Trend magazine's Truck of the Year three times.-----------------------------------------------------------------------------------------
Digimaster 3
0helpful
1answer

My son has a '91 Pulsar, 5 door hatch. When he changes into reverse, the gear "grates", we beleive the clutch needs to be adjusted, is this correct? (he has no bother with any other gear...

When the engine is idling and the gear box selector is in Neutral all the internals of the gearbox are rotating. Pushing in the Clutch disconnects the drive from the engine to the gearbox but it takes a few seconds for the gears in the box to cease rotating. All the forward gears have synchromesh so there will be no crunching noise ifa forward gear is selected immediately the clutch is pushed in before allowing the gears to stop spinning. On the other hand Reverse has No synchros and therefore selecting reverse before waiting a few seconds for the gears to stop spinning will produce the crunching noise you have described.
So it pays to wait a second or two after pushing in clutch before Reverse is selected to minimise the crunch and if the clutch appears to be working correctly in normal driving ,then no adjustment is necessary.
0helpful
1answer

Here are the issues with my 2000 Subaru Legacy L with 5 speed manual transmission: 1. ABS light illuminates when transmission is put in reverse and remains illuminated until car is turned off. 2. Reverse...

These assorted problems usually come from the control modules, in this case the transmission control module (TCM)
First, reset al ECM' by removing the battery negative terminal for a minute or so then re-fit it. This reset should cure all your problems. If not I shall consult my TSB's after you post the results of the reset.
0helpful
1answer

Sons avalanche suddenly stopped in drive. Can put in park and reverse no forward gear.

ON SOME GM'S IF YOU CHANGE THE TRANNY FILTER IT WILL FIX IT, I WOULD TRY THIS FIRST BEFORE I TAKE IT A SHOP
1helpful
1answer

Transmission problems

One of the solenoids in the transmission is acting up go to a transmission shop and have them code the transmission. Some repair shops can also check your transmission if they have the right Diagnostic tool.
0helpful
2answers

1991 Caprice No reverse. Moves in neutral. All forward gears OK.

shift linkage needs adjusting,,could be bent, easy fix, located along firewall to fram beneath the column, ask your son wut he ran over and didnt tell u about... hope i could help...:)
0helpful
1answer

NO REVERSE FORWARD GEARS WORK. IS THERE A BAND AJUSTMENT FOR REVERSE ?IF I PUSH IT OFF IT WORKS BUT SLIPS

I have a 2000 Honda Accord EX, it shifts normal on forward with no problem. Also when the car is cold the reverse gear works just fine, but when the car runs for about few minutes the reverse gear will not work. It will seem as if it wants to go but then if feels like its neutral.
Not finding what you are looking for?

71 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...