I got a new printed circiut board for my 1978 corvette and it works now but the callibration is way off. What do i do now?

For all 1978 Corvettes, the location of the Vehicle Identification Number (VIN) is stamped on a plate attached to the left front body hinge pillar.

buy a haynes manual at a partplace

It has been a few years, but I believe they screw on, try turning it counter clockwise.

check your fuses your light bolts and also check you wirring and connections

Yes they are basically the exact same harness, both are C3 Corvette

Go to Autozone.com and register your car for free. Then you can access wiring diagrams and fusebox layouts.

I hope you find this site helpful. Another is alldatadiy.com

Yes I do go to web site


www.ebscohost.com



ID tech
Pass tech

Everything you need is their and it is actually free beleive it or not

hope it helps

You may have a current that draws current when the car is turned off.
A stuck break light switch, an interior light or a short somewhere.

it is in the housing where the fuel line enters the carb. unscrew and remove the input fuel line, then unscrew and remove the housing. take note of the direction of the paper filter you remove. here's a page with more info on that car. http://www.carburetor.ca/carbs/tech/Rochester/Quadrajet-index.html