How to access. In side fuse box 2016 Ford Explorer have lost signal lights and cruise control

Hi,

you might need to update any associated battery or motor within that seat to overcome the motor issue. I would also apply cooking oil around the slide panel of the chair in order to allow it to have it's best chance of at least sliding between positions.

Thank you.

Question edited for clarity, full year make model, spelling 'Suburban' from Surburban.
Question moved to sub category.

No there isn't one. Cruise control is a joint effort from BCM and ECM. Check the Body Control Module fuses.

Fuse Box Diagram Chevrolet Suburban / Tahoe (2015-2020)

https://fuse-box.info > chevrolet > chevrolet-suburban-...
Here you will find fuse box diagrams of Chevrolet Suburban / Tahoe 2015, 2016, 2017, 2018, 2019, and 2020, get information about the location of the fuse ...

Chevrolet Suburban (2015 - 2016) - fuse box diagram

https://www.autogenius.info > chevrolet-suburban-2015...
Dec 31, 2017 - The underhood fuse block is located in the engine compartment, on the driver's side of the vehicle. Chevrolet Suburban - fuse box - engine ...

2016 model still under warranty take it in for warranty repair at a ford service center

The flasher relay is on the top side of the fuse panel which is

located under the dash on the driver's side. The owner's manual

suggests seeing the dealer for servicing of the relay box because the

fuse panel has to be moved to gain access.

THERE IS A BRAKE PRESSURE SWITCH MOUNTED ON THE MASTER CYLINDER. IF THE ABS LIGHT IS ON AND THE CRUISE CONTROL IS INOP. THE SWITCH OR WIRING TO THE SWITCH IS BAD. THERE SHOULD BE VOLTAGE IN AND OUT OF THE SWITCH IF ONLY POWER IN AND NO POWER OUT THE SWITCH IS BAD. ALSO CHECK FUSE #45 IN THE UNDER HOOD FUSE BOX TO SEE IF ITS GOOD. HOPE THIS HELPS.

Check the FLASHER, also can review the Fuses, located inside the passenger compartment, under the drivers-side of the instrument panel.

Both the turn signal flasher and the hazard warning flasher are mounted on the fuse panel on the truck. To gain access to the fuse panel, remove the cover from the lower edge of the instrument panel below the steering column. First remove the two fasteners from the lower edge of the cover. Then pull the cover downward until the spring clips disengage from the instrument panel.

The turn signal flasher unit is mounted on the front of the fuse panel, and the hazard warning flasher is mounted on the rear of the fuse panel.




To access the fuses, remove the fuse panel cover. Note the spare fuses (A) and provided fuse puller tool




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 1




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 2




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 3


Power Distribution Box
Located under the hood, in the engine compartment. It houses the fuses and relays for most of the under hood components which are not controlled by a dash mounted switch (such as the alternator, fuel pump, ECM, etc.). The fuses and relays are replaced in the same manner as the fuse panel inside the vehicle. The power distribution box cover is hinged on one end and utilizes a retaining latch on the other. Simply release the latch and lift the cover up to gain access to the fuses and relays.

Hope helped with this; remember rated this help. Good luck.

Hi,

There is a fuse to power the compass it is the central junction box.it is behind left of dash fuse number 21 takes a 5 amp fuse. If that fuse is ok you need a good scan tool to see what the instrument cluster is saying like codes. Good luck

Here is a link to the owner's manual for your Explorer. The fuse box layout with descriptions begins on page 187

http://www.motorcraftservice.com/pubs/content/~WO4EXP/~MUS~LEN/41/04expog3e.pdf

http://www.motorcraftservice.com/pubs/content/~WOXEXP/~MUS~LEN/42/99expog1e.pdf


Check fuses page for lables of fuses......

FROM LUSTY KID:

Check your bulbs first, I have lost both headlights on my ford at once on account of the bulbs burning out at the same time. Same thing probably happen, you have one filament out. The lights can work, but if the filament for brake is burnt, you don't see brake lights.

As for the cruise control. Check fuse box first. If OK check vacuum hose to actuator in engine compartment for starters.
Advise: