You can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
SOURCE: automatic transmission sounds like it stuck in 3rd gear
You need to check the transmission fluid level, if it is low the tranny will not shift. If, however, the fluid is to the proper level then you will need a new transmission.
Try putting new fluid in and look for a leak in the pan gasket, then all you may need is a transmission service. When the service is done the mechanic will look for pieces of metal in the old fluid, if found this is very bad and you will need a new tranny.
You might consider a new or used car, you can definately find a good deal out there!
SOURCE: 88 s10 pickup truck will not shift from 3rd gear to overdrive
need more info i had a 1984 chevy half ton and first, second, and third worked fine but lock up didnt work. the problem was there was no vacum at a switch under the hood on the fire wall also your shift linkage could be out of adjustment. try driving down the road and raise up a little on the shifter.
SOURCE: slight miss in engine, hard shift from 1st to 2nd long 2nd gear
Check both O2 sensor(s) and catalytic coverter.. P0420 means catalyst below threshold. Also check the sensor at the transmission and solenoid.
SOURCE: 02 jeep liberty won't shift into 3rd or 4th gear.
Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.
SOURCE: 96 chevy blazer 3rd gear and overdrive slipping
i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do
1,123 views
Usually answered in minutes!
×