Question about Dodge Cars & Trucks

1 Answer

Install ecm on 1991 dodge power ram 50 - Dodge Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

Find the Ecm under the hood on the passenger side and unbolt it from the firewall or fender wall and then take out the 10 mm bolt holding the wire plug in and just reverse putting it back together.. OH.. First remove the battery cable and you might want to check that your "New" Ecm is set up for your Ram 50.. Most ecm's have to be pre-programmed for make year model and Vin number..

Posted on Feb 05, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
heavymetal77
  • 721 Answers

SOURCE: Is a 1986 Dodge Ram 50 2.0 head the same as a 1987

Yes

Posted on Jun 23, 2009

  • 327 Answers

SOURCE: have a crack head on a 1988 dodge ram 50 got a

are the casting numbers on the heads the same ? if not just go to any machine shop that rebuilds heads and be polite and ask them they should take the time to look it up for you . hope this helps

Posted on Jul 24, 2010

  • 6 Answers

SOURCE: where is fuel pump on dodge ram 50 1988...

If its the same as my 1989 dodge ram 50 it sits on the engine block by the carburator

Posted on Jul 27, 2010

  • 34 Answers

SOURCE: i have a 1991 dodge ram b250 replaced battery

if your not getting juice from your alternator then it is bad the ecm doesnt supply the alt with juice the alt produces its own so if its not producing the correct voltage it will need replaced. it should make 14.75 volts in order to keep your battery fully charged ang to keep up with all running accesories. it should put out no less than 13 volts

Posted on Aug 07, 2010

redds55
  • 2620 Answers

SOURCE: Dodge ram won't start and ECM light and check

First you need to retrieve the trouble codes stored in the computer.If you don't have a code reader or scan tool you can take it to your local autoparts store (advance auto,autozone,ect) and they can retrieve them for you.Then we can go from there.

Posted on Jan 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a dodge ram 50 pickup.. Hard to start.. Once started it will idle... Try to pull out and it hesitates and wants to die.. Back off on the gas and sometimes it will idle or dies..


Dodge Ram 50 Pickup Questions - Page 5 - CarGurus

www.cargurus.com > Questions > Dodge

CarGurusGet fast answers to your Dodge Ram 50 Pickup questions from experts in the ... 1986 Dodge Pick Up 5.9 Wont Start I Put New Distributor Set The Timing, New.

Dodge Ram 50 Pickup Questions - Carburetor - CarGurus

www.cargurus.com > Questions > Dodge > Ram 50 Pickup

CarGurusCarburetor - I recently bought a 1989 2.6L Ram50 for my son. ... Asked by redoverfarm Apr 13, 2010 at 03:36 PM about the 1989 Dodge Ram 50 Pickup ... check your fuel injector...may be clogged dirty, get a fuel injector cleaner or carburator ... Also gets poor gas mileage and is hard to start when the engine is warm !

Dodge Ram 50 Pickup Questions - 87 d 50 2.0 runs ok ...



89 Ram50 wont start.. - DodgeTalk : Dodge Car Forums, Dodge Truck ...

www.dodgetalk.com > ... > Dodge Ram Truck 1st Gen (88 - 93) Forum
Sep 22, 2011 - Hey guys i got a 1989 Ram 50 and im hoping i can get some help here. She drives like a champ but she only starts when i push start it, once i ...

Dec 26, 2015 | Dodge Cars & Trucks

1 Answer

No power to fuel pump, No fuse for fuel pump, No in-line fuse for fuel pump. 1991 Dodge Ram 50 2.4L


The pump gets power from an engine control relay. The relay also powers the engine computer and the injectors. The relay gets power from a fuse and also from a fuseable link directly from the battery or starter.

Jun 15, 2015 | Dodge Ram 50 Cars & Trucks

2 Answers

I have a 1991 dodge ram b250 replaced battery alternator check fuses checked wires an still no juice from alt can my ecm be bad


if your not getting juice from your alternator then it is bad the ecm doesnt supply the alt with juice the alt produces its own so if its not producing the correct voltage it will need replaced. it should make 14.75 volts in order to keep your battery fully charged ang to keep up with all running accesories. it should put out no less than 13 volts

Aug 07, 2010 | 1991 Dodge B Series Cargo

1 Answer

Have a crack head on a 1988 dodge ram 50 got a head off 1991 dodge ram 50 can you use the 91 on the 88


are the casting numbers on the heads the same ? if not just go to any machine shop that rebuilds heads and be polite and ask them they should take the time to look it up for you . hope this helps

Jul 24, 2010 | 1988 Dodge Ram 50

1 Answer

Is leaking raw gas from gas tank


Find leak and repair or replace parts as needed. If there is a hole in the tank there are kits for temporary repair.

May 15, 2010 | 1991 Dodge Power Ram 50

1 Answer

88 dodge ram 50 4x4 manul trans. 2.6 mitshibishi.


the loss of power I was experiencing was because the secondary was not working. The vacuum was not strong enough to open the secondary.
I found a stronger vacuum and hooked it up there. Still need to fine tune the adjustments on the Carb. Have twice the power I had but still need adjusting.

Nov 16, 2009 | 1988 Dodge Ram 50

1 Answer

I have an 85 Power Ram 50. Has the electronic


If you drive it very little what I would recommend is to install an electric fuel pump. That way after its been sitting all you have to do is turn the key on and the pump will fill the carb.

Jun 08, 2009 | 1985 Dodge Ram 50

1 Answer

91 Dodge ram 50 ignition problem, rough idle in drive,dies when braking


my ram 50 starts just like any other vehicle, (no light switch pulling whatso ever), it sounds like somebody haas rewired something wrong or you have a loose connection and when you hit a large enough bump it cuts your power. Start it up and find a speed bump somewhere and drive over it enough to give your truck a jolt and see if it dies.

Oct 23, 2008 | 1991 Dodge Power Ram 50

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14063 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...