Holden vectra 03 v6 cdxi 3.2 How and easiest way to fix windscreen washer reservoir. It disconnected from the neck. I need to reconnect it.

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

How to check your Transmission Fluid Level

If it is an automatic transmission it will have an oil cooler in one of the radiator tanks. The fix is a new radiator unless you can find a radiator shop that is prepared to remove the tank and fit a new cooler core.

The clutch master cylinder will be the cylinder next to the brake master cylinder The reservoir may be on to of it or it may be connected to the brake master cylinder as later cars share the reservoir. Follow the line down to the bell housing and you will see the slave cylinder . The bleed nipple is on the top

Try a local non franchised specialist who may have engine torque figures in a vehicle specs publication.
I believe this is what we have in the UK as a Vauxhall Vectra V6, if I find something I'll let you know. In the meantime see whats on ebay on a cd?

that your windscreen washer bottle is low on fluid .you need to fill it up.otherwise you will not have anything there to wash your windscreen with when driving

PROBABLE CAUSE Impact to the front bumper pushes the bumper back far enough to break the washer pump hose fitting. CORRECTIVE ACTION Replace the windshield washer reservoir and washer motor with updated parts. REPAIR PROCEDURE 1. Turn the ignition switch to ACC (I) to unlock the steering column. 2. Raise the vehicle on a lift. 3. Remove the right front inner fender. Unhook and pull back the bumper for better access. CLIPS (6 places.) SCREWS (6 places.) RIGHT FRONT INNER FENDER 4. Release the hooks on the upper right side of the front bumper. 5. Remove the clip from the filler neck, then remove the filler neck. FILLER NECK CLIP WINDSHIELD WASHER RESERVOIR CLIP WASHER MOTOR CONNECTOR BOLT BOLTS WASHER TUBES 6. Remove the right front fender trim, and disconnect the washer hose from the 90-degree fitting. CLIP FRONT FENDER TRIM FRONT HOSE 7. Disconnect the 2P connector and the two washer tubes from the washer motor. 8. Remove the washer reservoir clip and the three bolts, then pull out the reservoir. 9. Assemble the new reservoir components, but do not install the filler neck. 10. Trim 85 mm off the end of the 1,260 mm washer tube only. 11. Route the washer tubes on the reservoir. NOTE: The black fitting is for the front windshield nozzles, and the white fitting is for the rear nozzle. 85 mm 12. Install the reservoir. 13. Connect the rear tube to the straight fitting in the wheelwell. 14. Connect the 2P connector to the washer motor. NEW RESERVOIR Connect the rear washer tube. CLIP BOLT 9.8 N•m (7.2 lb•ft) 15. Install the filler neck with the original clip. Connect the front washer tube to the 90-degree fitting. Then reinstall the front fender trim. WASHER FLUID DIPSTICK 2P CONNECTOR FRONT FENDER TRIM FILLER NECK CLIP

It sounds as if there is a blockage either in the base of the screenwash reservoir or the feed pipe from the reservoir. You could remove the screenwash reservoir tank and clean it out and at the same time check the pipe.

Please remember to rate this solution.