That is going to be a wiring fault between your seat belt latch and the body control module or a defective seat belt latch.
SOURCE: All the back seat belt stuck, and you can not fasten them?
pull the back seat bottom up. should be able to pull forward and up
SOURCE: need to replace driver seat belt latch . Do you
yes, the seat has to come out , you may possibly hae to pull the seat frame apart. make sre the vehicle is not equiped with seatbelt pre-tensioner.
SOURCE: 1997 Dodge 2500 4 wheel drive pickup - Both Front
Seat belts lock up when the belt is pulled on as the pendulum is rocking, and it could have been released at this time on a hill. This would make the belt lock up. But it should not do that when it is coiled up as the spool is full and the lock is pushed out of the way. You may have to force it to release by pulling and jerking on the belt as you are standing out side of the truck, not moving! Use a flash light to check the pocket for debris....
SOURCE: stuck seat belt
Remove the panels to the belt, normally these can miss roll and get stuck. Unbolt the unit so you can get some slack that should be enough to release and pull it back out to correct it. If that will not do it get a replacement from a junkyard and replace.
73 views
Usually answered in minutes!
×