Any codes? Go to a store like parts source they will check for free. Any other problems? What could be related to stalling?
Testimonial: "Like I said in the comment, no code from the dealer. The lights, the radio, the fan are working, the only signal is Red dot blinking under the Neutral symbol in the dashboard."
When stall try to push gas pedal while when you turn ignition on.
I'll try next time, as mentioned is intermittent problem, can drive two weeks without problem. Just a detail when is stalls and try to turn ignition, nothing happen I means not trying to turn, no noise from starter, looks like no electric signal to starter. Thanks for you help.
×
SOURCE: Car starts, drive a mile, stalls.
try haviing your alternator checked advance auto parts can check it while its on the car and the can check the battery too. if thats not it it may stall due to a loose battery connection or a loose ground strap. if it stalls and everything turns of (electrical) it may be a connection or ground strap.
SOURCE: 2005 Dodge caravan dashboard indicator lights and dials went haywire
2005 Caravan I had the same problem with my van gauges bounceing, headlights not comeing on when the switch was turned on.I took a day and downloaded a wireing diagram from dodge and studyed it.GROUND PROBLEM dodge have several ground conections to the body then there is one MAIN BODY GROUND.This is most likely your problem it is easy for any back yard mechanic to fix.This main body ground is located under your battery box.You will have to remove the battery and then the battery box becarful of the battery sensor that is mounted in the bottom of the box.Also there is a hose that you will have to disconnect but dont try to remove it from the box remove it from above the box.After you get the battery and box out you will see a threaded stud with a black wire conected to it this will be rusted because of no antioxide grease applyed.You will have to remove the nut and wire connector clean both and the stud with wire brush or sandpaper.Put antioxide grease or if nothing else some vaseline to keep it from coroading again.put back together and see if this dosent fix your problem.It has been six weeks for me now.good luck.dont forget that neg battery terminal is the first one to disconect and the last to reconect.
SOURCE: 2000 buick lesabre stall after starting or after running for 30 minutes
I have a 1996 Lesabre. I had a similar problem that slowly got worse. I brought it to two different mechanics that did diagnostic checks and could only "suggest" what to replace to fix the problem. Their problem was that it wouldnt stall out while they had the mv. After replacing a bunch of sensors and the fuel pump/ filter, I solved the problem by replacing the Crank Sensor. Its located behind the lower crank pulley on the 3.8 lt motor. Hope this helps!
SOURCE: My 1989 Mercedes Benz 300E
The inside of the ignition dealer (Delco) must be thoroughly cleaned and all metal parts passed with fine metal wool. Sparkplugs must also be cleaned or renewed. The air inlet-valve is very sensitive. The cylinder and the disc must be carefully cleaned with light metal wool and contact cleaner. The fault is due to the disc remaining stuck in the cylinder, so no idle function and malfunction of the auto-choke system. If this solution does not work, then the vacuum pressure is defective.Hint from a German Mercedes specialist.
SOURCE: won't start, security light blinks for 10 minutes
there is a computer chip in the lock cylinder that goes bad ,so change the key and cylinder,then leave new key on until the light stops flashing about ten minutes this will set your new key to the security system hope this helps
Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake
576 views
Usually answered in minutes!
Brings to dealer, have scanned it: no code, nothing that can help
×