Question about 1998 Land Rover Range Rover

2 Answers

How to program a new hyundai sonata key fob. Already have a key fob, but after losing it for a couple of days at work (it was returned) decided to buy a spare from a dealer in case it got lost again, but I don't know how to program the new fob.

Posted by on

  • Anonymous Mar 24, 2014

    Lost fob key jeep compass 2011 have a regular spare key car will not run how override

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

First find little notch on side of FOB that will allow you to open the FOB itself. Next insert mini flathead and twist hard until unti snaps open. Hopefully you didnt break it yet. Then pull out circuitboard within FOB. nEXT remove battery and press red button and hold for 5 seconds. Replace Battery then put circuitry back in place. Now, with circuitry in place hold all three buttons while simultaneously pressing the red circuit overload reset button on the board. Then, press the thre buttons in this exact order ( this is a very important step) press the door unlock buttton twice before waiting three seconds then pressing the hood open button 3 times followed by a 5 second delay then pressing lock> But wait, before you press lock you must "chime" this code to the song "waiting for a girl like you" by foreigner. The code will then automatically find your cars code, get married and then you will be in luck - many baby remotes will start to fall from your dash board. If this doesnt work it is probably due to the fact that you have more of a hard rocker or redneck remote and follow all prior procedures but replacethe song with only "welcome to the jungle" or tears in my beer". If this still doesnt work, grab a beer and share it generously with your remote. When this doesnt work, (as I suspect at this point it wont) take your remote and after finishing the 12 pak, take the remote to your local hyundai dealer and threaten to throw up in the main sales room if they dont program it for you. Mae sure you slur the fact that your dad owns Hyundai (even though you are as white as can be) and that you will sue them all out of work if they dont do this for you ...plus you then proceed to puke on the front door handle and tell the customers " this is what you have to look forward to if you get oneof these BEutieeeesss hahahaha" while rubbing your puke infested hands all overtheir nice shirts and blouses, ....this I promise will work. And you should have a nicely programmed remote the next morning after waking up in the drunk tank and the officer gives you a ride home because the mayor of "yourtown" is your neighbor and your supposed to be at home cooking a barbeque for him that after....HIC...that after...HIC that ...noon.

Posted on Apr 23, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

Dealer will probably have to program.

Posted on Aug 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Australian Hyundai Sonata GLE Classique key fob will not turn off immobilizer. Have replaced batteries. Can a new remote be coded/programmed or will I have to buy a new ecu. Please help.


You will not have to buy a new ECU. Key fobs are programmable. Try inserting the key in the drivers door and lock/unlock to see if security resets. Also try disconnecting battery and reconnecting

Oct 18, 2015 | Hyundai Cars & Trucks

1 Answer

HOW PROGRAM THE KEY LESS ENTRY FOR SONATA 2012


  1. Cars
  2. Car Maintenance
  3. General Car Maintenance
  4. How to Program Keyless Entry Remotes in a Hyundai Sonata
How to Program Keyless Entry Remotes in a Hyundai Sonata By Christian Killian, eHow Contributor
20Found This Helpful The keyless entry system in your Hyundai Sonata is part of the factory alarm system. If you have to replace a lost or damaged remote, reprogramming will be necessary. The remote is important because not only does it lock and unlock the doors, it also arms and disarms that factory alarm when you open or close your car doors. New remotes are available from any Hyundai dealer. While they will program it for you, you can do it yourself and save a programming fee.
How to Program Keyless Entry Remotes in a Hyundai Sonata(Kleophaus Livingston/Demand Media)

Other People Are Reading


Step 1: Locate the fuse panel under the dash on the driver's side of the car. Just below it is the control module for the factory alarm system. Open the cover on the alarm system control module and locate the memory switch inside.
(Kleophaus Livingston/Demand Media) Step 2: Verify that the switch is in the "Off" position; if it is not, switch it to the "Off" position. This is important for the system to understand what you want it to do when you move to the programming mode.
(Kleophaus Livingston/Demand Media) Sponsored Links
Step 3: Insert the key into the ignition of your Sonata and turn the key to the "On" position. Wait for 60 seconds, then move the memory switch inside the control module to "Set."
(Kleophaus Livingston/Demand Media) Step 4: Depress and hold the "Lock" button on your remote for one full minute. This allows the remote and the control module to communicate and sync. Release the "Lock" button and turn the memory switch in the control module back to the "Off" position.
(Kleophaus Livingston/Demand Media) Step 5: Turn the ignition switch to the "Off" position and test the remote by pressing the "Lock" or "Unlock" button, verifying that the doors do lock or unlock.


Read more : http://www.ehow.com/how_6362326_program-entry-remotes-hyundai-sonata.html

Mar 29, 2015 | Hyundai Sonata Cars & Trucks

1 Answer

How to program key fob for 2000 sonata


think this is a dealer only task .

Mar 27, 2015 | 2000 Hyundai Sonata

1 Answer

Crimestopper SP501 car alarm/remote starter will not respond. The 2 way one doesn't work, the sidekick does.


You need to program your crimestopper sp-501 key fobs, you need to program both the 2-way and the 1-way key fobs, during the same key fob program session. First find your valet button/switch, when you have found it, turn your ignition on and press the valet button four times, if you have a toggle type switch for a valet switch, toggle it up and down four times, when its in remote key fob program mode, it will honk your horn 4-times followed by 4-parking light flashes. Once your have done this press the lock button on the 2-way key fob, horn will honk and the 2-way will sing a little song to confirm programed, then press the lock button on the 1-way key fob the horn honk will be your confirm programed. turn ignition off this will exit you from program mode. then shut all doors and test key fobs for operation functions....hope this helps you out

Dec 03, 2011 | 2006 Hyundai Sonata

2 Answers

I have a 2003 hyundai sonata and i dont have the remote for the stock alarm. My alarm keeps going off and my car wont start. I bought a new battery and even tried the key in the door still no luck.....


The 2003 Sonata is equipped with a 'starter KILL' burglar alarm system with disables the starting system (using a N/C 'contacts' configuration instead of a N/O contacts configuration). N/C=Normally closed, and N/O=Normally open contacts. When the alarm goes off with a MY Sonata, the only way to DISARM it is with the key fob (remote) originally programmed for it (unless you purchase a new remote & have it programmed for the vehicle at an authorized Hyundai Service Department). NOTE: So long as the keyless entry & burglar alarm system is functioning/operating normally, the alarm will keep going off and the STARTER KILL function will still prevent you from starting the vehicle. One option is left without purchasing a new remote and having it programmed.
1. When the alarm goes off, get into the vehicle and insert the ignition key into the ignition.
2. Turn the key to the 'RUN' position (NOT the ACC position) and wait for the alarm to STOP (usually about 3 to 5 minutes).
3. The engine should then start using the ignition key.

If this procedure doesn't work, the problem will need further diagnosis by a qualified/certified Hyundai Service Technician.

Hope this helps

Aug 27, 2011 | 2003 Hyundai Sonata

2 Answers

I need a replacement key fob (clicker) for my 2006 Hyundai Sonata. I've seen some on Ebay, but I've only lost my money when buying there, so I'd rather try something else. Can you help me? The dealer's...


Unfortunately Ebay is the only secondary market for your keyless entry FOB.

There are many reputable sellers on there that will stand behind their product and replace anything deemed defective. I would look for a seller with numerous transactions and a high user rating. A business that has sold 2000 items for example, and has a user rating anywhere above 95% is a pretty good bet.

When you get your FOB, if your vehicle is still under sny kind of warranty, you should take your FOB to them and tell them it quit working, they will program your new FOB for free under warranty.

Jan 07, 2011 | 2006 Hyundai Sonata

2 Answers

Programming key fob on 2006 sonata


Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.

Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.

The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.

I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.

Good luck and Rate this.

Cheers

Jan 02, 2010 | Hyundai Sonata Cars & Trucks

1 Answer

Key fob will not lock or unlock doors on 06 Sonata


Hi there
i have the same problem but mine is the sensor that is under the dash that is faulty so i had them disable it untill i can get a part that they need to order so i would have your dealer check the sensor .. if it is under warranty they will replace it for free

Mar 02, 2009 | 2006 Hyundai Sonata

Not finding what you are looking for?
1998 Land Rover Range Rover Logo

7,897 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...