We got another computer an car is sitting and again oil in the same conection
Security relearn procedure. Turn key on for 10min, security light will go out, do this 3 times, on the 3rd time start the car, sometimes they are difficult to do so it may take more than one try, all this is assuming the security light is on and stays on when the key is in the on position.
You got another computer from where ? Was it programmed ? Anti-theft system key's programmed to new computer also ? Oil pressure switch is in the black connector - have seen bad oil pressure switch wick oil through the wire strands into the computer ,also bad coolant temp. sensor do the same thing .
SOURCE: oil change 2007 chevy malibu maxx
2.2L takes 5 quarts
3.5L and 3.9L take 4 quarts
Both quantities are with oil and filter change
SOURCE: 2002 Chevy Malibu - Oil in Coolant Tank
Sounds like your head gasket has a leak. I would also check your dip stick. If there is coolant mixed with the oil also. Then it is your head gasket.
SOURCE: I have a 2005 Chevy Malibu. The check engine
"This indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake
vacuum to siphon the fuel vapors into the engine."
Hope that helps..
SOURCE: where is the oil filter on a 2005 Chevy Malibu
you probably have a 2.2l ecotec engine. open your hood, its, right side on engine, right center of engine compartment. find your oil filler cap and look lower. its a black oil filter housing. 1"1/4 socket fits it or your can get a special socket for this housing at oriellys for about 10 bucks, your engine holds 5qts of oil. acdelco oil filter pf456g
SOURCE: Steering knock/pop while turning on 2005' chevy
CHECK RACK AND PINION FOR LOOSE OR MISSING FRAME MOUNTING CLAMP AND GROMMET.THAT WILL CAUSES KNOCK NOISE ON TURNS.
91 views
Usually answered in minutes!
fwd the engine details on
[email protected]
×