The part where your back rests
SOURCE: Install Rear Speakers Ford F150 1997 Regular Cab
you should not have to remove the panel by taking the four phillips screws out of the speaker grill you will pull out through front
SOURCE: how to remove backseat backrest to change seat cover from 05 f150
u have to start by taking the bottoms out. then the back there should be two bolt to take out and it slides up and pulls off
SOURCE: Ford 2004 F150, Lariat, crew cab I have a
I had the same problem with my truck,ieven took it to a window repair shop while driving home it started to rain lord a behold,I looked on the back sit and it was wet.After all that i found out that the water was comming in from the break lite on top of the roof.all you have to do is take the cover off and replace the seal around the cover because it is worn out or get some sealeant and place it around the inside cover.
SOURCE: rear axle removal on a 2004 f150 fx4
First thing is to make sure you chock the front tires so the truck will not roll. Raise the rear end and set it on jack stands. Put the transmission in Neutral and make sure the parking brake is off. Remove the rear tires and disassemble the brakes on the side with the leaking seal. Place a drain pan under the rear differential and remove the cover. Remove the differential shaft lock bolt. You will need to turn the drive shaft by hand to access the bolt. It will be on the right side off the spider gear housing. Only use a 5/16 or 8mm 6 point box end wrench to remove the bolt. After you remove the bolt reach on the top of the spider gear housing and push the differential lock shaft down to remove it. Make sure the spider gears do not rotate after you remove the shaft. If they do you will need to realign everything to reinstall the lock shaft. Push the axle shaft in enough to remove the "C" clip from the tip of it. The axle will now slide out of the rear end. You can use the tip of the axle shaft to remove the axle seal. If you're changing the bearing as well you will need a slide hammer with axle bearing adapters to remove it. You can use a socket and hammer to install the new bearing and seal. Be careful not to damage the bearing and seal. I recommend packing grease in the back side of the seal. This helps prevent the spring on the seal lip from coming off. Assembly is the reverse. Clean off all the gear oil from the differential cover and the axle. You can use RTV as a gasket if the OEM gasket is damaged. Fill the rear end with new gear oil of the proper type. Refer to your owner's manual.
SOURCE: How do I remove the
see a plastic cap type thing attached to the seat where the rod of the headrest goes in feel this cap and you wil find a puch button press it and pul the head rest
357 views
Usually answered in minutes!
×