2005 Chevrolet TrailBlazer Logo

Related Topics:

Thelma Sidney Posted on Jan 25, 2019
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Have 2005 chevy trailblazer check engine light came on. Mechanic say it is fuel evapor lock changed fuel cap week later light came on again

1 Answer

Arnie Burke

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chevrolet Master 7,339 Answers
  • Posted on Jan 25, 2019
Arnie Burke
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 23, 2009
Answers
7339
Questions
0
Helped
1820935
Points
21459

Ur evap system in tank area has issue...probly the solenoid. Get a smoke test done and a scan

5 Related Answers

Anonymous

  • 1201 Answers
  • Posted on Jan 31, 2009

SOURCE: 2006 Chevy Aveo Check Engine Light coming on and off

It needs a code scanner hooked up to it,to tell you why the light is on and the cause. If there is an autozone near you take it there or
call different auto part stores to find out if they do that.Without getting the code, it's just guessing what the problem is.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 26, 2009

SOURCE: check engine light code PO456

most likely the pressure sensor in the fuel tank for the evap system is defective.

Anonymous

  • 3 Answers
  • Posted on Jul 22, 2009

SOURCE: 2005 trailblazer check engine light on

Verify any "check engine" by first resetting the computer then waiting to see if it returns. To reset the computer, disconnect the battery cable (some say either cable, I say positive{red} cable). Leave the cable disconnected for about 30 minutes then reconnect it and start the engine. Because the cable was disconnected from power for a while, the computer will have to reboot upon startup. Just like any computer, sometimes a reboot will solve the hangup. If the error returns, it is likely a sensor is bad or the sensor is indicating a true problem.

Anonymous

  • 1 Answer
  • Posted on Oct 06, 2009

SOURCE: VSC/ Check Engine Light

My 2000 Lexus GS 400 just had the VSC/VSC off light and the check engine light come on. I would have to push the accelarator peddle all the way down to get it to go. Took it to the Toyota dealer and the code pulled up as the Throttle Position Sensor was out. Purchased one and having it put in. Will update if this fixes the problem.

Anonymous

  • 216 Answers
  • Posted on Apr 14, 2010

SOURCE: 2005 mazda 3 2.3l that is burning oil (no leaks)

possibly the pcv but check if your cars exhaust smoke is blueish or white in color if it does and your car doesnt have an oil leak then sure its burning engine oil along with fuel, the piston rings is defective, since you replaced engine oil the additive that the owner has put with the oil to prevent blowby is gone thats why it starts burning oil.....

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

2006 Chevy Trailblazer LS. What fuse controls the EVAP Canister Vent Solenoid please?

there are like 1billion cars noW doing this.
  1. the gas cap was loose or bad !!!
  2. theN the driver did not know it takes 30 driving cycles to clear the CEL lamp. OOPS 30? OBD2 DOES THAT. PER SERVICE MANUAL RULES, IF YOU READ THEM.
  3. the fuse did not blow, or you'd have not asked where it is, I get that.!

99% of the time the cap was just loose or bad
my car the 1% time, the purge solenoid stuck
and my walmart silicon spray'd there (INSIDE IT) ended FAILURE for 50,000 more miles.
learn to buy AND USE a scan tool (borrow, rent ,buy)
tighten the cap again
scan the pCM see the cel lamp reasons./
push reset on the toll (CEL goes off if lucky and not 100 other DTC errors set)
and drive 3 times or more and the CEL stays off.


the other resets are(NO SCAN TOOL,. REALLY?)
1: PULL BATTERY LUG FOR 15MIN AND PUT BACK
OOPS RADIO GOES DEAD. dang
2: PULL ALL IOD FUSES. THE PCM MEMORY FUSE ONLY.
Ecm F29 IS IT(MEM) (PCM) 10AMPS
ALL DTCS NOW GONE, STORED. THE DATA FELL; INTO THE BIT BUCKET AS THEY SAY

IF ALL TESTS AND WILD GUESSING REPLACING ALL EVAP; VALVES. THEN COMES THE SMOKE MACHINE TESTS.
TO FIND THE LEAK
THIS IS AND EPA MANDATED MONITOR IN USA.
FOR SURE. THE 2 FUSES FOR BOTH EVAP VALVES ARE HERE.
evap-undefined-undefined-0_0.jpg
0helpful
1answer

I have a 2005 grand prix v6 not super charged. the check gas cap came on a week ago and i replaced it and it still shows up. Last night while accelerating the car would not go then its jumped and start...

your gas cap light told you of a seal leak at the fuel tank. check all other line connections to the fuel tank the make sure they are tight. could also be a fuel pump losing pressure
2helpful
3answers

2005 mazda 3 2.3l that is burning oil (no leaks)

possibly the pcv but check if your cars exhaust smoke is blueish or white in color if it does and your car doesnt have an oil leak then sure its burning engine oil along with fuel, the piston rings is defective, since you replaced engine oil the additive that the owner has put with the oil to prevent blowby is gone thats why it starts burning oil.....
1helpful
1answer

2005 chevy cavalier problems

NEED TO CHECK THE CODES PROBABLE EMMISSIONS LEAK,GROSS OR SMALL,GO TO ADVANCE AND LET THEM SCAN FOR FREE
0helpful
1answer

2006 Saturn Relay Check Engine Light

PO455 is a large evaporative fuel leak. A bad fuel cap is ONE of the things that COULD be the problem. Fuel system cleaning only lightened your wallet. Reading your post is confusing. Did all this start AFTER the Valvoline Wallet Flushing? If so , they left something loose or disconnected. I would find a qualified repair shop to fix the problem, and if it has anything to do with what Valvoline did, make them pay the bill.
10helpful
3answers

I have a 2005 Chevy Malibu. The check engine

"This indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine."
Hope that helps..
3helpful
2answers

2002 Chevy Trailblazer w/101,000 mi has the P0440 OBD II Code. Just replaced the plugs with Iridiums @ 100K, all connections are good and gas cap is seated properly . . . help!!!

i have 2003 trailblazer ltz 153 000 mileage i have code po440 .i changed gas cap and turned off the chech engine light... i made 300 miles and it was good and today morning i drove a mile and light turned on ..... what do i have to fix ...thanks
Not finding what you are looking for?

190 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...