If it will not hit with spraying starting fluid, that indicates that you have a no fire condition. Start at the spark plugs and work your way in from there. Wires, coil, crank trigger, fuse.
SOURCE: Rds radio Procedure
GM DELCO THEFTLOCK RADIO UNLOCK CODE:
1. Press and hold presets 2 and 3 for about 5 to 10 seconds until you
get 3 digits on your display. This is the first 3 of 6 digits you will
need, so write 'em down.
2. After doing step one and writing down the code, immediately press
the
AM/FM button to get the last 3 of the 6 numbers you'll need, and write
'em down. (if you wait too long between steps 1 and 2 and the LOC code
displays again, just start over).
3. Call this number, it's a prerecorded message, so don't worry about
having to talk to anyone...1-800-537-5140. The voice will ask if
you're
calling for Chevy, Pontiac, Cadillac, etc... When you here him tell
you
to press "2" for Pontiac, press 206010 and hit the # key. He'll ask
you
for the 6 digit code that you've written down. Enter that and press
the
* key. He will then give you a code, and the option to get additional
4
digit codes, but one should be sufficient.
4. Follow the normal procedure in your owners manual for unlocking the
radio with your new code...press the hour set button on your radio
until
you get the first two numbers of the code, then press the minute set
button until you've entered the last two numbers. Immediately press
the
AM/FM button once the correct code is entered and the code SEC or
"secured" will be displayed on the display screen. Now, just turn the
radio on, and your ready to roll.
There is an additional step you can take to remove all codes from the
radio and start from scratch by entering your own personalized 4 digit
code so that it won't get you in a pickle again! Just repeat step 4
and
you should get a display screen that reads ---. This means the code is
out, and you can now program your own code. Of course, once you
receive
the 4 digit code from the GM recorded message, just keep it in a safe
place, because you can use that same code again and again should you
have any more problems with it in the future. Good luck, and yes, it
does work.
SOURCE: chevy astro van turns over but wont start when
Check to see if the fuel pump is kicking in,
when you turn the key on without starting the van you should hear it kick on for about 2 seconds,
It could be...
A clogged fuel filter...
Blown fuse for the pump..or bad pump relay..
No gas
Bad fuel pump
SOURCE: 2000 chevy express 1500 van having starting issues
Start with fuel system. Listen for fuel pump humm at fuel tank No humm check wiring to pump for power. Then check for spark at plugs and wires. Remove wire from coil and hold near engine and see arch when you crank. No arch. Replace ignition Modular inside distributor cap or cap or rotor
SOURCE: air bag light wont go off after cycling 04 chevy express
YOUR VEHICLE HAS DETECTED A FAULT IN THE AIRBAG CIRCUIT IT WILL HAVE TO HAVE CODE RETRIEVAL DONE TO DETERMINE WHAT CAUSE LIGHT TO STAY ON,I URGE YOU TO DO THIS SOON AS WHEN AN AIRBAG SYSTEM HAS GIVEN A FAULT CODE AND TURNED ON THE LIGHT THE SYSTEM IS DIABLED AND WILL NOT PROVIDE PROTECTION IN ACCIDENT
Testimonial: "I tried what you suggested, and it worked the light cycled an went out thanks , david"
SOURCE: how do I change front turn signal light on 2006
If you look at the gap between the fender and the grill on the outside edge of the grill at the level of the turn signal, you will see a grey tab, if you push on this tab while pulling out on the lamp assembly. The whole assembly should swing out and allow access to the bulbs.
Hope this is of some assistance.
Ed
191 views
Usually answered in minutes!
×