Question about 2014 Ford Fusion

1 Answer

2014 Ford Fusion has vibration when shifting to revesre and when stopped going up hill. Runs good otherwise.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    Visited the website for 30 consecutive days.

  • Ford Master
  • 613 Answers

Sounds like a clutch problem, how many miles has vehicle done ?

Posted on Jan 23, 2019


6 Suggested Answers

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: 1993 Ford Tuarus Gl

have the catalytic converter checked

Posted on Sep 02, 2008

  • 495 Answers

SOURCE: Driveline vibration 2007 Ford Fusion AWD

Has the car even been in an accident? If so it could be a bent frame (worse case), Otherwise the car could be off balance and needing an alignment (Most likely - best case) :)

Posted on Dec 28, 2009

  • 394 Answers

SOURCE: What could be causing my 1997 Ford E350 15

ABS------ Anti Lock Brakes will cause a chatter if applied with a lot of weight pushing it. An E350 is a big rig.
Might ask your Ford Tech about that possibility.

Posted on Mar 05, 2010

  • 560 Answers

SOURCE: 2002 ford expedition shifts fine but when you start to go up a hill then it feels like it going in an out of overdrive untill you give it a little gas some one help please

try turning the overdive button off if the problem goes away then its proprob. a tcc solinoid or the converter itself i would have it ckd 4 codes 1st and have the trans fluid flushed and and shudderfix avail. and most parts stores

Posted on Jun 04, 2012

  • 55 Answers

SOURCE: 1995 ford explorer check engine light is on

Get a shop to read the codes from the engine computer. You can do it yourself by grounding a pin on the diagnostic connector and counting the flashes from the check engine light. The code will tell you which part is causing the problem- usually an oxygen sensor or an EGR problem on these engines.

Posted on Oct 26, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

04 F-150 not wanting to up shift after down shifting for grade, what do I start checking first?

If your talking about OD, still going down hill with no gas pedal applied. It won't. This would be normal because TCC lockup applied runs off the TPS and MAF sensors also. If on level ground and it does work I would look to the MAF sensor. Cleaning it first can help, but they have been know to be out of perimeters and not throw a code.

Apr 13, 2016 | 2004 Ford F150

1 Answer

How to remove and replace passenger side mirror on a 2014 ford fusion

Replace Your Car Passenger Side Mirror - How To - DIY ...

? 3:46
Apr 10, 2012 - Uploaded by GregHint
See how even a novice can repair a passenger mirror on a FordEscape. ... Replace Your Car Passenger Side Mirror - How To - DIY .... Replace 2003-2008 Toyota Corolla Side Mirror, How to Change Install 2004 2005 2006
About 22,000 results (0.61 seconds) Search ResultsHow-To: Replace Ford Fusion side mirror (HD) - YouTube? 7:27 7, 2014 - Uploaded by Derrick HardingFord Fusion SEL 3.0 Liter V6 How to fix broken side mirrorIncludes: ... Published on May 7, 2014 ..... Great instructions - just replaced the driver's side mirror on my 2007 Fusion following your instructions. ... Front brake pad replacement 2006 - 2012 Ford Fusion Lincoln Mazda Pads Rotor Install Remove ...

Jan 08, 2016 | Ford Cars & Trucks

2 Answers

2014 ford fusion engine wont crank after wreck

Ford fusion won't start - YouTube

? 2:01
Sep 16, 2014 - Uploaded by mlmunoz21
Ford fusion won't start ... Published on Sep 16, 2014 .... 2004-2008 F150 Died Out No Crank Theft Light ...

Ford Fusion won't start - YouTube

? 0:32
Jan 9, 2015 - Uploaded by Nicholas A.
Any ideas why it won't start? 2007 ford Fusion awd 6 cylinder. ... And P1260 2007 Ford Fusion - Theft ...

Nov 02, 2015 | 2014 Ford Fusion

1 Answer

My clutch is getting stuck and not coming back up when I release it, it's a 2006 Ford Fusion

On the WEB

2006 Ford Fusion Clutch questions - AR15.Com Archive
Dec 18, 2014 - 4 posts - ‎3 authors
2006 Ford Fusion Clutch questions - AR15. ... Clutch pedal stops half way up intermittently yesterday. Today stuck on floor. ... With the rope you can get into a pushdown...pull up rythm on the pedal without having to stop to get

Jul 31, 2015 | Ford Cars & Trucks

3 Answers

Why does a 2006 Ford Fusion have a strong vibration when stopped and in Drive?

If there are no check engine lights could be a bad motor mount or two. Would have them checked. Try putting car in neutral and see if vibration disapates a little.

Aug 23, 2012 | 2006 Ford Fusion

1 Answer

I have a 06 ford fusion 80,000 miles. recently I have had a jerking problem from the rear. The first time this happened I thought someone hit me from behind.

I am only going to guess

You may have a bad EGR Valve,if it slams,bucks,etc,with the slightest amount of gas applied or won't go up any hill. Disconnect the vacuum lines to the valve,plug them and road test to confirm

I hope you have changed your trans fluid, at least twice in 80,000 miles (I used to own a trans shop)
Forget the TV Ads and owners manual,change it and flush the power steering,every three years,not more than 30,000 miles
Flush brake fluid ever two years.

If you still have problems, consider the Trans Solenoid Contol Pack,( remove trans pan to replace)
If the tach ever flairs up, and the shifts are not crisp,stop driving it immediately and change solenoids

Nov 09, 2010 | 2006 Ford Fusion

1 Answer

Shifts hard when taking off and passing,will stall going up a hill then **** and take off

EGR Valve a possible. If you have vacuum lines going to it ,disconnect, plug, and see if problem goes away.

Sep 15, 2010 | 2006 Ford Fusion

1 Answer

Will not shift out of park

Is it your vehicle parked Up Hill or Down Hill. If it is then next time try to use parking brake put your lever in N and set the parking brake then put it in Park. Next time you will have less force on your transmission.

Dec 31, 2009 | 2009 Ford Fusion

1 Answer

Driveline vibration 2007 Ford Fusion AWD

Has the car even been in an accident? If so it could be a bent frame (worse case), Otherwise the car could be off balance and needing an alignment (Most likely - best case) :)

Dec 28, 2009 | 2007 Ford Fusion I4 SEL Sedan

Not finding what you are looking for?
2014 Ford Fusion Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

84581 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides