How do I reset tpms on 2013 ford explorer - Explorer Ford Cars & Trucks

Videos here

https://www.google.com/search?q=2013+Ford+Explorer+replace+heater+blower

..

Does the vehicle have TPMS - tire pressure monitoring system ? Who ever did the job didn't relearn TPMS sensor positions . Take it back .

http://enginepartsdiagram.com/2007-2015-toyota-camry-tire-pressure-monitoring-system-tpms-reset

reset/ recalibrate the monitor of the tire pressures

Normally, correcting low tire pressure will re-set the system and light will go off, however, if TPMS units inside wheels get low batteries, light will stay on. Very common for these units to be replaced when you buy new tires.

disconnect the battery then reconnect this will reset everything.

Replacement TPMS sensors have to be programmed to your car after installed using an expensive programming tool/computer. There are also a bunch of different versions and frequencies of wheel sensors, so unless the dealer did it (unlikely) check and make sure it is the EXACT required part.

Did you try to disconnect your NEGITIVE battery cable for about 1 minute? You can buy a reset tool or go by a tire shop that can do that also

The tire sensors are on the base of the valve stems of the original wheels. Do your new tires/wheels have TPMS valve stems?

Unless you buy wheels with TPMS (tire pressure monitoring system) sensors in them, or put your old wheels back on, the system won't work.

La luz TPMS del tablero se enciende cada 100km e indica "fallo en el sensor"