Question about 1981 Chevrolet Corvette
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Intermittent hard power steering, at the begining of the turn of the steering wheel, once disturbed past the hard part, works normal.
Had fluid change, I notice a sensor, on the control block tower of the rack, is this at fault ? thanks buckleyeng.
Posted on Sep 24, 2008
SOURCE: ignition cylinder won't turn
I had the same problem in a 94' trooper. Basically the Ignition lock cylinder is wore out and you need a new one. Mine wouldn't turn past lock and no matter what I tried it wouldn't turn. You can go on auto zone and find the part, mine was about 61 bucks, it comes with keys and the ignition cylinder. The deal is that to get your new ignition cylinder in you have to get your original turned to off or acc I can't remember. You'll see with your new ignition cylinder that when you turn the key there is a button that can be depressed but only when the key is turned past lock and it also won't depress in start. First, disconnect battery and wait like 30 minutes. So, what you do is take a screwdriver handle and place it up against key and take some pliers or something and beat on it a couple of times, this gets the key in deep enough to where you can eventually turn it. I swear it will eventually turn, once there, take off the top and bottom plastic covers off steering wheel/unscrew electrical wires on back of ignition cylider and other side and you know the button I referred to basically you have to depress that with key in acc or off and it will slide out. If your having trouble finding the button look at new ignition cylinder in comparison to old one and you can see where the depressed button is on side closest to you, you'll see a little hole up on the side of housing that you can depress.
Posted on Apr 15, 2009
Sounds like the begining of a bad rack n pinion. We can eliminate the pump because the car turns to the right fine. There is no loss of fluid? The only thing left is the rack. It is a fairly commin issue. Use to call it morning sickness, The cars would be hard to turn in the morning or when first started but after running and warming up for a while they would start to work properly.
Posted on Jan 20, 2010
Tips for a great answer:
Sep 04, 2017 | Cars & Trucks
Dec 02, 2014 | Chevrolet Corvette Cars & Trucks
Aug 15, 2010 | 1996 Toyota Camry
May 31, 2010 | 1991 Toyota Celica
Nov 07, 2009 | Ford Mustang Cars & Trucks
Oct 23, 2009 | 1980 Chevrolet Corvette
Oct 12, 2009 | 2000 Ford F350 Super Duty Super Cab
Oct 02, 2009 | Isuzu Rodeo Cars & Trucks
Sep 02, 2009 | 1966 Ford Mustang
Mar 17, 2009 | 1996 Nissan Sentra
22 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: