Question about Dodge Cars & Trucks

2 Answers

2006 5.7 L Hemi Dodge Ram water pump labor time

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Expert
  • 40 Answers

This basically depends to mechanics but its 2 to 3 hours job including coolant fill up and system bleeding thanks

Posted on Jan 20, 2019

  • daniel k nakwafila
    daniel k nakwafila Jan 20, 2019

    This basically depends to mechanics but its 2 to 3 hours job including coolant fill up and system bleeding thanks

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 35 Answers

2.3 hours. So figure about 2.5 hours to do the job with adding coolant and bleeding system. Hope this helps.

Posted on Jan 20, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: Dodge Ram 1500 can it have a plow?

Yes It can and It should not void the warranty. Contact your dealer.

Posted on May 15, 2008

  • 1 Answer

SOURCE: time clock change on dodge ram navigation radio

Press "NAV" to go to the main navigation menu.

Scroll down and select "System Settings"

Scroll down and select "Clock Setting"

Make sure "Show GPS Clock" is selected with a red check in the box.

I had to switch "Daylight Savings" from "ON" to "OFF" in order to bring the time back an hour. I assume that I'll just have to switch it back to "ON" in the Spring in order to move the time forward and hour.

Posted on Jan 28, 2009

  • 1 Answer

SOURCE: blower motor makes loud noise when on high

I have a 2004 dodge ram 1500 with the same problem, vibrating blow fan when on high, pulled the blower fan out and found a piece of the hinge from the recirculation door and felt the recirculation door sitting up on the vent of its hinge. Crappy engineering once again.

Posted on Jun 07, 2009

  • 226 Answers

SOURCE: unable to remove fan from water pump

Remember, fan has a reverse thread. Righty-tightey, lefty-loosey does not apply. You need a clutch fan wrench. (available at your local auto parts store.)

Posted on Aug 16, 2009

wilsodfarm
  • 986 Answers

SOURCE: torque specs. for outer tie rod ends for 2006

Tie rod end is 35 ft. lbs. Pinch bolt for the lower ball joint - 105 .I hope this helps you

Posted on Oct 06, 2009

Testimonial: "thanks for the help"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump relay location and designated number in fuse box for 2006 dodge ram 1500 5.7 hemi


If you hear the pump kick on when you cycle the key, what makes you think you have a fuel problem? Have you used a fuel pressure gauge to see if you have correct fuel pressure?

Jul 28, 2015 | 2006 Dodge Ram 1500

1 Answer

2006 Dodge 1500 5.7 hemi-Changed the power steering pump. 1,500 miles later the steering is very hard at low speeds. Is there air in the system, bad pump, or maybe rac & pin issue?


Indicates the pump not producing enough,in park rev the engine to say 1200 rpm and see if it acts the same as 20mph turn steering at same time.

Jun 30, 2015 | 2006 Dodge Ram 1500

1 Answer

Where fuel regulator is located on dodge ram 1500 hemi 5.7 2006


I believe it's part of the fuel pump in the tank.

Jan 23, 2015 | 2006 Dodge Ram 1500

1 Answer

2006 dodge 1500 hemi-trouble codes p0700 and p0800, what are they?


the P0700 means Transmission Control System (MIL Request)
the P0800 means Transfer Case Control Circuit

hid conversion kits

Aug 27, 2012 | 2006 Dodge Ram

1 Answer

The 5.7 hemi 2006 dodge ram 1500 losing coolant tekućinu.U hole oil emulsion is created and drops of antifreeze. At the bar there is no oil emulsion oil is clean.


II got a dodge 1500 4.7. The problem is, the oil cab is all green and im losing coolant all the time, there's smoke coming out smells bad, but no check engine at all. So I took it to a shop to check it they said, it's a water pump ,I changed the water pump but still losing coolant ............ so is it head gasket, manifold gasket, valve stem seal, piston rings, or something I don't know of??

Feb 04, 2011 | 2006 Dodge Ram 1500

3 Answers

05 5.7 hemi burning 1 qt every 700 miles


Rings & bearings & oil pump need urgent attention!
Cheers Rob

Sep 19, 2009 | 2004 Dodge Ram 1500

1 Answer

Unable to remove fan from water pump


Remember, fan has a reverse thread. Righty-tightey, lefty-loosey does not apply. You need a clutch fan wrench. (available at your local auto parts store.)

Aug 16, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84565 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...