SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
SOURCE: diagram for spark plug rewire sequence
i have a complete Chrysler workshop manual in pdf if you want..
SOURCE: where is cylinder #1 on a Cadillac V6 engine 3.6
Right bank is 1,3,5.and left bank is 2,4,6.Hope this helps.Good luck.
SOURCE: spark plug wire wireing diagram
For the 2002 Toyota Tacoma:
I do not know if you have the 2.4L, 2.7L or the 3.4L; however I have included all three below.
For the 2.4L AND 2.7L:
Firing Order:
1-3-4-2
Cylinders:
(back)
...4
...3
...2
...1
(front)
Ignition Connections:
(back)
___
o <----4
o <----3
___
o <---2
o <---1
(front)
For the 3.4L:
Firing Order:
1-2-3-4-5-6
Cylinders:
....(back)
5.............6
3.............4
1.............2
....(front)
Let me know if this helped, or if you have an additional information or questions. Feel Free to contact me at FixYa.com!
1,544 views
Usually answered in minutes!
×