How to replace motor 4.6 ford f150 2003 - 2003 Ford F-150

Don's 1999 Ford Ranger shift motor PROBLEM SOLVED ...

? 13:05
https://www.youtube.com/watch?v=wcn39gwPWfI
Oct 1, 2013 - Uploaded by gtarman49
Don's 1999 Ford Ranger shift motor PROBLEM SOLVED. ...How to find replace fix 4x4 transfer case shift module 2002 Ford Explorer 4 wheel ...

How To Install Replace 4x4 Transfer Case Shift Motor Ford ...

? 9:15
https://www.youtube.com/watch?v=9ldrtZODxQ8
Oct 26, 2010 - Uploaded by 1A Auto Parts
How To Install Replace 4x4 Transfer Case Shift Motor Ford Explorer .... transfer case shift module 2002 Ford Explorer 4 wheel drive not working ...

How to find replace fix 4x4 transfer case shift module 2002 ...

? 3:07
https://www.youtube.com/watch?v=sZw3SS2Pt-4
Nov 3, 2013 - Uploaded by kirk colombo
... transfer case shift module 2002 Ford Explorer 4 wheel drivenot working ..... I replaced the transfer motor so i think it is the control module.

How To Install Replace Blower Motor Heater AC Fan Ford ...

? 9:30
https://www.youtube.com/watch?v=zasspzTCrSo
Oct 4, 2010 - Uploaded by 1A Auto Parts
How To Install Replace Blower Motor Heater AC Fan Ford Explorer ... This procedure should be the same or similar on 95, 96, 97, 98, 99, 00, ...

FORD FIESTA ZETEC 1 4 TIMING BELT REPLACMENT part 1 FORD FIESTA 1 4 DURATEC TIMING BELT REPLACMENT pt2

The thermostat is on the fan actuator, the fuse may be on the fuse strip or box, either under the dashboard or under the hood, close to the windshield.

By now the blower motor should have been replaced a few times so hopefully it will be less hard. Disconnect the orange power wire at the rear of the right hood hinge and the black ground from the upper cowl. Remove the right front tire and wheel assembly. There should be an access panel in the fender. Remove it and you should see your blower motor. Remove the 4 motor mounting screws and disconnect the cooler tube from the motor. slide the motor and wheel assemby out the acess hole.
Hope this helps.

sounds like you getto chase wires but did you try the sillinoid befor u put it in. if not take it out and have some one try to push the button and see if it enguages

hte blower resistor is shot, near the blower motor, have the blower motor checked my guess is that it requiring too much power to run, hence the blown fuse

You should see three star screws, Remove these and the motor should come off. Check the plastic plugs in the motor and replace with plugs or ball bearings, pack with wheel bearing grease. You may have a defective window regulator. To remove. using a /14 inch punch punch out the rivits and replace with 1/4 nuts and bolts. Drill out the aluminum inserts using 1/4 drill. When replacing the regulator do not over tighten the bolts holding in the glass.

if this is shift on the fly 4x4(electronic shift),check all fuses first.Try lightly tapping on the 4x4 electric motor on the transfer case,if it changes,replace the 4x4 motor.Water and dirt get in the 4x4 motor,causing it to stick.

Your blower motor resistor has gone bad, it should be located next to your blower motor in the car, held in place with a couple of screws, remove it and replace it. The resistor is responsible for making the blower motor run at slower speeds than high or (4). Let me know if this helps.