I want to take out the chime buzzer or speaker in my 98 ford windstar get rid of it all together but where is it located?

SOURCE: can a 96 Ford Windstar Air Conditioner Compressor Pump Fit in a 98 Windstar?

The compressor is the same but it may have a different pulley and the plug may be indexed on the wrong side. If you have a set of snap ring pliers you can put your coil and pulley on that compressor or it may already be the same ones just make sure you put the plug where it is on your original compressor.

SOURCE: 1998 Ford Windstar AC compressor

They get more than warm, but not excessively hot that you can't touch it. This can be caused by a faulty condenser fan motor, dirty condenser coil even low freon, which is my guess along with a dirty condenser. Check these two issues and if it's not the problem your compressor may be getting ready to die. because of internal issues with the motor windings. Make sure the fan is running to speed, clean the condenser and see if the larger copper pipe to the compressor is ice cold and sweaty, if not you may need freon

SOURCE: Having problem's with my 98 Ford Windstar

Check  transmission fluid level first. Make note if the fluid color is dark brown and smells burnt you probably have a serious problem. If fluid is full, you probably have pump failure. Trans will need to be overhauled or replaced.

SOURCE: I need the location of

up by the throttle body itself

SOURCE: remove fuel pump from tank ford windstar 98

To gain access to the fuel pump, it is necessary to remove the fuel tank.

1. Depressurize the fuel system and remove the fuel tank from the vehicle.
2. Remove any dirt that has accumulated around the fuel pump module attaching flange, to prevent it from entering the tank during service.
3. Turn the fuel pump module locking ring counterclockwise using a locking ring removal tool or a brass drift and remove the locking ring.
4. Remove the fuel pump module.
5. Remove the seal gasket and discard it.

1. Put a light coating of grease on a new seal ring to hold it in place during assembly. Install it in fuel tank ring groove.
2. Insert the fuel pump module into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
3. Install the tank in the vehicle.
4. Install a minimum of 10 gallons of fuel and check for leaks.
5. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF , then repeat the key cycle five to ten times until the pressure gauge shows at least 30 psi.
6. Check for fuel leaks at the fittings.
7. Remove the pressure gauge.
8. Start the engine and check for fuel leaks.