Where is the ECU located on my Lexus 2000 rx 300

Question edited for clarity, add maker.
Question moved to model category.

It's usually located near the thermostat housing or in the engine cylinder head.
Dec 17, 2020

Lexus RX300 Engine Coolant Temperature Sensor ...

You have 2 of them,here's a link showing where their at,once you get to page,click on switch and relay. SENSOR KNOCK CONTROL 176 07 Fits LEXUS RX300 1993 2005 Part 8961512090... Here's a video showing you where they are at. 2000 Lexus Es300 Knock Sensor Location Repair

usually stamped into the block so look for a flat section just below cylinder head good hunting

what size of bulb for the moon

For 2000 Lexus RX300 3.0 liter DOHC V-6 (1MZ-FE) check this diagra...




Hope this helps (remember to rate this free answer).

To get codes you need a code reader compatible to your ECU. Usually 1996 and up use an OBD2 system located underneath the dash somewhere. You connect your OBD2 reader to the connection point and start your diagnostic. It will then read back to you what codes the ECU is reporting. You then look up the codes online or through an autoshop and they can tell you what is causing you problems.

YOU CAN BUY A HAYNES REPAIR MANUAL.IT HAS PHOTOS TO SHOW YOU AND TELL YOU HOW TO REPLACE PARK LIGHTS.

you most likely have an "air gap" or "tone ring" problem with one of your sensors or tone rings. i would suggest letting a technician diagnos which problem it is, as it is a diagnosis that requires some experience.

the location and type of noise u hear is most likely coming from the electric blend door temperature control actuator.when they fail the ting gears inside make a clicking noise like this, the location you gave is dead on to where this part is located.

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-fareast-font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Lift the hatch. The tall center light is located behind the upper hatch inside panel. There are two panels need to remove. One panel is on the right, the other on the left. To remove the panels you have to use flat screw driver to pry out the panel in several locations. (These panels are secured by several small metal clips.) Be careful to collect all these clips and replace them on the back of the panel. You will need these clips to replace the panel later on. After remove the panels, you will be able to locate the screws on the tall center stop light assembly. Remove those screws and cover. After replacing light bulb. Assemble everything in reverse order. Remember, the metal clips have to set on the back of the two panels not the car body.