Hello Rodney, If you notice a lack of flow from you tail pipe when you increase the engines RPM or a lack of power when stepping on the gas while driving you may have a plugged catalytic converter, muffler or a obstruction in a exhaust pipe. If you have any doubts after checking the above, get it into a shop to be tested...plugged exhaust systems can cause excessive heat build up and damage your engines exhaust valves.
SOURCE: How to remove ignition cylinder from Toyota Camry 1993
Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!
CAUTIONSome
models covered by this guidemay be equipped with a Supplemental
Restraint System (SRS), which uses an air bag. Whenever working near
any of the SRS components, such as the impact sensors, the air bag
module, steering column and instrument panel, disable the SRS, as
described in .
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
SOURCE: Does a 1998 4 cylinder Camry have a timing belt or chain...
it has a belt, it's supposed to be replaced every 90,000 miles
SOURCE: 1998 toyota camry , 2 codes, p0171. + p1133
P0171 lean code. Clean the maf sensor. A f sensor is inthe exhaust pipe.
SOURCE: 1998 toyota camry le 4 cylinder How do you set the
Just make sure the timing belt is on properlyy, lining up the cam and crank in proper position to each other. The engine willstart when fully assembled because the electrical has not be altered. If it has a crank position sensor , be sure to put it back on after cleaning it and the connector.
SOURCE: how to replace ignition lock cylinder on 1998
MOST TOYOTA LOCK CYLINDERS, HAVE A RELEASE PIN OR LEVER. WHEN YOU BUY THE NEW LOCK IT WILL PROBABLY HAVE INSTRUCTIONS, OR YOU CAN SEE HOW THE OLD ONE COMES OUT
40 views
Usually answered in minutes!
×