Question about Hyundai Elantra

1 Answer

I have a 2000 hyundia elantra that will not shift into rev. starts fine, forward gears fine. trany oil ok not burnt up to level. any ideas

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 94 Answers

See if ur ableto shift it at the trany with ur hand into gear go to underhood or under car to the transmission disconnect the leankage should popoff with screw driver maybe hard but it just pops up have someone start car hold foot on brake with ebrake on and shift it one click should be reverse take ebrake off and see if it goes in reverse if it does its ur shift solinoid right there werelinkage clips on if dont its inside ur transmissoin

Posted on Jan 02, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: I bought a 2000 Hyundai

The input and output transmission sensors may be bad. My car had this malfunction. I replaced the sensors and have had no more problems.

Posted on Jul 21, 2008

  • 4 Answers

SOURCE: Auto Transmission 2000 Rodeo

It seems that the trans is slipping. The smell is from excess trans flood. If Trans is over filled, it can rupture seals and cause leaking that can get on the exhaust and burn.

Posted on Dec 03, 2008

  • 6982 Answers

SOURCE: 02 jeep liberty won't shift into 3rd or 4th gear.

Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.

Posted on Mar 16, 2009

ghost4548
  • 776 Answers

SOURCE: hyundai excel 1996 automatic will engage reverse

It appears you have a Forward Clutch FAILURE. Replace the trans after you get it diagnosed and verified by a professional technician. By the way, do you have a Check Engine light? If so, what is the diagnostic code? The dealership can scan the system and find any codes which may have been stored in the TCM (Transmission Control Module). If there were any 'Incorrect Gear Ratio" codes, it's most probably the trans itself.

Posted on May 28, 2009

  • 99 Answers

SOURCE: 2000 Hyundai Elantra gear shift stuck in Park.

check for the brake switch if this doesnt work wont release from park if this ok then i will check the shifter cable check for power and ground

Posted on Aug 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 hyundai elantra drives fine forward but when shift into reverse it won't move. What could be the problem


Hi. Thanks for your question. For assistance related to gear oon Hyundia elentra 2003 model you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!

Mar 26, 2018 | Hyundai Cars & Trucks

1 Answer

Car does not shift when cold and bangs from park to drive runs fine when warmed up had a trans flush last week still having problems 2000 elantra 4 cyl


check the oil level by applying handbrake then start engine and put in reverse ,then check oil level if oil level ok have a drive around dealers and trade it in quick before you have to pay out for a new gearbox

Feb 17, 2011 | 2000 Hyundai Elantra

1 Answer

89 Jeep Cherokee Pioneer w/AT4 auto tranny behind 4.0 engine. When cold, tranny works fine, but after 2 to 4 miles, won't engage in any gear manually or automatically, and won't engage in 4WD. After...


This sounds like all checks have been done, the oil is fine and the linkage is good, soory to say your trany is in need of a rebuild, sounds like in internal leak or weak pump, i would have a trany shop check it but i can tell you there going to say it news rebuilding. good luck.

Nov 07, 2010 | 1989 Jeep Cherokee

1 Answer

I have a 2000 golf 2.0 (automatic) it is not shifting properly. check engine light is on. when i drive @ 30-40mph it revs between 3-4rpm when usual it would be @ 2. what could this be?


the first thing i would do would be to check the trany fluid level,make sure engine is warm and then check, some of these vws dont have dip sticks to check the trany oil level,theres a procedure to check,so if yours doesnt have a dip stick you should take it somewhere and have the level checked and also check for leaks,if the trany oil is full then i would have the trany checked, also that check engine light may have something to do with the shifting problem,have the computer scanned, the codes will help you diagnose the problem,auto zone will scan it for free, there are other parts places that will also scan and give you a read out of the codes stored in the computer, hope this helps.

May 17, 2010 | 2000 Volkswagen Golf

1 Answer

'93 Hyundai Lantra, automatic transmission has trouble changing up from 1st to 2nd, it tends to rev on a bit, clunks once or twice before changing to 2nd, other gears seem to be ok. Oil levels are ok and...


\'93 Hyundai Lantra, automatic transmission has trouble changing up from 1st to 2nd, it tends to rev on a bit, clunks once or twice before changing to 2nd, other gears seem to be ok. Oil levels are ok and have recently replaced the transmission oil (yes the correct oil was used)

Jan 16, 2010 | 1993 Hyundai Elantra

1 Answer

2000 Hyundai Elantra gear shift stuck in Park. Car will start and runs fine. We just can't get the gear shift to move out of Park.


check for the brake switch if this doesnt work wont release from park if this ok then i will check the shifter cable check for power and ground

Aug 20, 2009 | 2000 Hyundai Elantra

1 Answer

1998 Hyundia Elantra Oil light will not go off,


check oil pressure switch connector and switch

Mar 03, 2009 | 1998 Hyundai Elantra

1 Answer

2000 hyundia automatic


does your car vibrate when shifting gears ??
your problem could be either worn gears on the transmission or the transmission mounts.
if the car vibrates when shifting then most likely are your transmission mounts, when they get worn the transmission will move a little out of place and you will have problems shifting.
if it doesn't vibrate probably are your gears and transmission will have to be repaired.

Jun 28, 2008 | 2000 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...