SOURCE: 1997 Buick Park Avenue
This is the diagram but you should have factory belt diagram sticker is still somewhere under the hood
If not:
http://www.mvreader.com/multiview/dayco/zoom.php?zoom_item=C0001D&l=n&catalog=auto&category=
To replace the serpentine belt on a V6 3800 you must jack up the motor and remove a motor mount. You must then use a breaker bar with a socket (13/64") and pull it toward the front of the car to release the belt tensioner. Put the new belt on, tighten it, put the mount back on, and lower the jack.
Driving without a belt can cause the motor to overheat, will cut power steering, and will not recharge the battery, so you should probably get a tow
Good Luck
SOURCE: 1991 buick park avenue will not run fuel pump is good and replaced the fuel filter
http://www.fixya.com/cars/t1810766-1991_buick_park_avenue_stop_running
Check out this link. It may help you with your problem.
SOURCE: How do I remove the rear door panel on my Buick Park avenue
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 2000 Buick Park Avenue Service engine soon light
need to take car somewhere to have the code read with a scanner,try parts stores first some will do it for free if not the dealers have them
SOURCE: FUSE IDENTIFICATION FOR 97 BUICK PARK AVENUE
Several Fuse Panel locations there; all fuse's description can find it in 1997 Buick Park Avenue Owners Manual (page 331 and next).
Hope this help (remember comment and rated this post) TY for using Fixya.
110 views
Usually answered in minutes!
×