SOURCE: 1994 toyota corolla alternator belt replacement
loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.
do the reverse on installation.
remember to tighten all bolts of the adjuster and alternator after tightening the belt.
tnx 4 using fixya,
drcool
SOURCE: toyota corolla 1994
theres no cable in toyota corolla 1994 check the speed sensor or replace speedometer have same problem with my 1993 toyota corolla
SOURCE: what is needed to fix fault codes 14 and 24 for a
The following is from a Haynes manual for 1993-1996 toyota corolla and geo prism:
Code 14: ignition signal. No ignition signal to the ECM. Check igniter or circuit, ignition coil, ig. switch or circuit, ECM (engine control module or "computer")
Code 24: intake air temperature sensor. Open or short in the intake air temperature sensor circuit. Check intake air temp. sensor or wiring to ECM.
SOURCE: where is the oxygen sensor located on a 1994
You need to follow your exhaust. You have two. One in the front and one in the back. All you do is plug one side into the electrical connector and the other side screws into the exhaust. You need to find out if it is the upstream sensor or downstream sensor before you change that one. The one in front is upstream.
SOURCE: 1994 toyota corolla brake lights won't turn off
Thanks for choosing FixYa and welcome. You need to check the brake switch. Your brake pedal contacts the brake switch when it is pressed down. There is a small button on the brake switch that activates the lights. It may be stuck or broke. Try to loosen the button first. If it won't, buy another one. They only cost a few dollars.
1,748 views
Usually answered in minutes!
×