SOURCE: audi Q7 transmission rear crossmember broke down need to remove member bolt
I think that it wouldn't be a good idea to use en electric arc welder as the current generated by the welding poles could damage small integrated components. May be you sould try drilling them out instead.
Cheers
SOURCE: how to tighten uo the hand break cable on my bmw
You'll need to remove the center console that is over the hand brake. (screws and clips will most likely be hidden)
Once the console is off, you should be able to see two cables connecting to the base of the lever (one cable on the left of the lever and one to the right as these control the ebrake on their side of the car respectively.
Loosen the nut and you can shimmy the cable to tighten it.
Don't do it too tight or your ebrake may be engaged even though the lever is all the way down.
SOURCE: remove bateries from audi q7 remote and required disassembly.??
- Buy a CR2032 3V battery
- Pry open the battery cover on the remote using a flat head screw
driver or a table knife. The pivot point is the chain ring holder opposite to the key.
- Replace battery
SOURCE: 2010 audi q7 shows on
It's the normal car service reminder due. Whichever will be reached first: 700 km, or 30 days. In other words after 700 km, or if you don't drive the car 700 km within 30 days, you should carry out the car maintenace: engine oil & oil filter, air filter, fuel filter, pollen & dust cabin filter, ...
Then you will need to reset the "Service due" message on the dashboard. For Audi Q7 made year 2010, the Service Interval Indicator can only be reset with the VAS 5051 or similar diagnostic tool connected to the data link connector of the car.
SOURCE: I need the time diagram of the chain sprockets' inside 2008 Audi Q7 3.6 FSI
go to nearest autozone and they will print out diagram for you at no cost. I have done this alot.
63 views
Usually answered in minutes!
×