Question about Ford F-250 Super Duty

1 Answer

Front lights dont turn on. on a 2000 ford f250 super duty disel

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Ford Master
  • 3,540 Answers

I would look for a problem with the headlamp switch. Also it could be in the multipurpose switch which is part of the turn signal switch I have seen both problems. You will need a test light that will light when you probe 12 volt wire. Follow the 12 volts from the fuse box, some trucks fuse the headlamps, so make sure they are all aright. Follow it to the head lamp switch to make sure it has current and if it does, probe the wires that are connected to the multipurpose switch. Make sure that the headlamps have a good ground and that they are both not bad.

Posted on Feb 20, 2019


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1010 Answers

SOURCE: abs light on

I'm a Ford service adviser. There are many reasons for the
abs warning indicator to come on. The usual cause is from a
faulty speed sensor. Either a wheel speed sensor or the
differential speed sensor. I don't think the light is related to your vandalism. You might want to take the truck to an auto parts store and have them read the codes for you. Most auto parts stores will do this for free.
Good Luck

Posted on Jun 23, 2008

  • 3 Answers

SOURCE: 2000 ford f250 super duty 4x4 7.3L diesel oil leak

The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.

Posted on Jun 23, 2008

  • 41 Answers

SOURCE: 1999 ford f250 super duty 4x4 will go into 4

transfer case selector switch or equivlent to is bad or connectors to the switch is bad dose it do only when it rain or moisture underneath.

Posted on Jan 19, 2010

  • 102 Answers

SOURCE: My horn does not work on my 2003 Ford f250 super duty PU truck.

The horn location is on the radiator support.

Posted on Mar 08, 2010

  • 1857 Answers

SOURCE: My ABS light comes on at times on my 2006 Ford F250 SD

you need to get the code in order to proceed. one of the tire sensors is most likely erratic. You wont know which one without a proper diagnosis.

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Ford F250 6.0 disel runs out of coolent and no leakes smell of coolent in the cab

smell the exhaust after you fill it up and see if it's burning in the engine if you smell the antifreeze it's going into the combustion chambers it could be a leaking gasket or a cracked head or engine block if not look around the radiator/hoses or the weep hole under the water pump your leaking from somewhere if you don't smell it in the exhaust

Feb 17, 2015 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Ford F250 Super Duty 6.0L Disel acts like it is missing from timing as a gas would

diesels missing is an indication of faulty injectors . I would have they pulled and the tips replaced.;

Jan 01, 2014 | 2006 Ford F-250 Super Duty

1 Answer

My f250 disel does not start up till 3o4 tries just white smoke comes out of the exhaust pipe

I suspect that you live somewhere where it has started getting cold. Your glow plugs are not working properly. If the system appears to be working, then check the plugs themselves. They do burn out. Hope this helps.

Nov 02, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

How do I replace the front turn signal lightbulbs in my 2000 Ford F250 Super Duty?

There are 2 screws on the bottom side of the turn part of your truck. The orange or clear on some models. In between the bumper and the lights you will find them. Remove the 2 screws then you need to pop the turn light out of the sockets in the header panel they fit into. Just apply even pressure to the outside by the fender with your fingers and wiggle until it pops loose and then do the same for the inner one. Once completely loose you can then turn the bulb socket which will pop out and you can see the bulb. Push in and turn the bulb counter clockwise until it releases and remove it. Replace it and reassemble in reverse!

Feb 06, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

I dont know which fuse is for interior light on 2000 f250?

If you have the owners manuel the fuse board diagram is in there.

Feb 21, 2009 | 2001 Ford F250 Super Duty Super Cab

2 Answers

2000 ford f250 super duty front windows and door locks

les ecribo dede la patagonia, compre una ford 250, año 2000, tuve un choque y la camioneta no anduvo mas, quiero saber como se desactiva el sensor de choque , ya que la camioneta no funciona el motor.
Cristian Luna

Jan 11, 2009 | 2000 Ford F250 Super Duty Crew Cabs

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides