The C22o Sunroof works fine as far as opening and closing....all appears to be normal except the aft end of the roof does not rise up flush with the roof of the car...I can use the hex tool to drive it up manually but when operated electrically the next time it remains low in the back by about 1/3 inch...any adjustments that can be made??? thanks
Unfortunatly these roofs are basically a complete unit with cable and frame all in one unit where as previous roofs had replacable components. Assuming yourr roof seal is not torn or damaged you can adjust the glass somewhat. There are 6 torx style bolts that secure the roof to the tilting brackets. I would raise the roof in the pop up position and carefully remove the side bellows(They are also a common failure and can cause roof to bind or not operate to complete rest postion)-they pop out by pulling outward. Just remove the bottom section so you can easily reinstall them. Next loosen the back torx screws( I beleive they are size t20) and push roof up as far as you can and resecure. If only one side is not popping up as far as it should just do that side. Then try resynchronizing the roof parameters by pushing the button untill roof is in forward postion and hold for approximatly 10 seconds-next push button untill roof is in pop up position and hold for 10 seconds. You can also loosen all 6 screws by popping off the plastic trim piece in front of roof and loosening the screws and pushing roof all the way forward. but you will spend alot of time adjusting utill roof is perfect. good luck
305 views
Usually answered in minutes!
×