How to remove radiator on 2001 pt cruiser - 2001 Chrysler PT Cruiser

SOURCE: chrysler pt cruiser fuel filter location?

Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module

Greg Bernett

• 2993 Answers
• Posted on Oct 31, 2009

SOURCE: Location of powertrain control module on 01 PT Cruiser?

The PCM attaches to a bracket welded on the dash panel

SOURCE: replacing a starter in a PT. Cruiser 2001

Remove battery and battery support you'll be able to undo starter bolt's trough there and slip starter out.

Testimonial: "This didn't help, because you had to remove the engine structural collar under the starter to get at the starter bolt. It was more complicated."

Greg Bernett

• 2993 Answers
• Posted on Apr 18, 2010

SOURCE: how do i remove radiator fan from my 2004 pt

Hope this helps!

Removal & Installation
NOTE The fan motor, fan, and the shroud are serviced as an assembly.



CAUTION Do not open the radiator draincock with the system hot and under pressure, because serious burns from coolant can occur.

1. Disconnect negative cable from battery.
   
2. Remove battery and battery tray.
   
3. Drain cooling system below upper radiator hose level.
   
4. Remove grille.
   
5. Remove upper radiator closure panel and center brace.
   
6. Disconnect upper radiator hose from radiator.
   
7. For turbocharger equipped vehicles: Remove radiator inlet neck.
   
8. Hoist vehicle.
   
9. Disconnect radiator fan electrical connector (.
   
10. Remove the two lower and left side radiator fan screws and.
    
11. Lower vehicle and remove the remaining radiator fan attaching screws.
    
    WARNING Care should be taken not to damage the radiator cooling fins and tubes during fan removal.
    
    
12. Remove radiator fan by lifting up from the engine compartment.
    

1. Install the radiator fan into position on the radiator.
   
2. Hand-start all radiator fan fasteners.
   
3. Tighten all radiator fan retaining screws to 55 inch lbs. (6 Nm).
   
4. Connect the radiator fan electrical connector.
   
5. Carefully lower the vehicle.
   
6. For turbocharger equipped vehicles: Inspect radiator inlet neck O-ring. Replace if necessary. Install radiator inlet neck. Torque fasteners to 55 inch lbs. (6 Nm).
   
7. Connect the upper radiator hose to radiator. Align hose and position clamp so it will not interfere with the engine or the hood.
   
8. Install upper radiator closure panel and center brace.
   
9. Install grille.
   
10. Install battery tray and battery.
    
11. Connect cables to battery.
    
12. Fill cooling system.
    

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP