It is hard to say without looking at it. I use a professional scan tool to look at live date and perform some tests. If shutting the vehicle off does reset the system then it may be a fluid level, temperature, pressure or internal transmission control component to blame. How does the transmission fluid look (Is it clean and red)? How is the transmission fluid level? The transmission filter does have a life expectancy. Was the transmission fluid and filter serviced on time? I hope this helps. Please let me know if you need additional information. Good Luck.
SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: limp mode?
It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature, disconnect the battery for a few minutes and reconnect to see if the code resets. I hope this helps.
SOURCE: 2002 pt cruiser codes p0725 engine speed sensor
i have this same problem with my pt cruiser did you ever figure out what was wrong with it
thanks let me know my email is [email protected]
SOURCE: EML, Check Engine, Limp Mode
What is limp mode, and it is MiL light( mal function indicator light)it is not EML. Please specify so i can help
SOURCE: No tail lights on 2007 pt cruiser
check the bulbs the filiments could be broke, do you have a third brake lightand is it working this will help rule out a brake switch
464 views
Usually answered in minutes!
×