Question about Hyundai i20
When I was working at Hyundai we used to torque pretty much all heads the same way.
Torque to 30nm from inside working your way outward.
Torque to 60nm from inside working your way outward.
Lastly torque to 90nm from inside working your way outward. Doing it this way you will not need to retorque after 1000kms
Posted on Mar 28, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
Posted on Aug 29, 2009
If you have a vehicle application for the motor you can get a Haynes or Chilton manual from your local auto parts store. They usual run around $30.
Posted on Sep 04, 2009
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
big ends- 1 - 26nm 2 - 52NM
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
Posted on Sep 23, 2009
SOURCE: Torque setting for peugeot 206
If you have normal 1.6 liter 206:
max bolt lenght:176,5mm
20Nm and aditional 240°
1,6 liter 16valve engine
max bolt lenght:122,6mm
20Nm and aditional 260°
Posted on Sep 26, 2009
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
Posted on Feb 19, 2010
Tips for a great answer:
Jul 20, 2016 | Hyundai Cars & Trucks
May 11, 2016 | Hyundai Santa Fe Cars & Trucks
Dec 19, 2015 | Hyundai Cars & Trucks
Mar 31, 2012 | 2008 Hyundai Tucson
Aug 18, 2011 | Hyundai Motor 1996 Elantra
Sep 24, 2009 | 2003 BMW 325
Aug 31, 2009 | 1995 Hyundai Elantra
90 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: