I would say its the same fuse that the lights use. If the tail lights work, its probably not the fuse but the globe or the wiring to the globe or a poor earth.
SOURCE: Changed 3 fuses now car wont start
you need to check battery supply most important. if the battery low voltage, cause no start. if the battery ok & strong energy. maybe the drive away protection control if this is the problem you need to bring to BMW dealer to replace control & ENCODE the control unit using SSS.
SOURCE: 98 jeep tj, dash light/taillights/licence plate light don't work
disconnect head lights, and replace fuse. Then turn the light back on to see if it blow a fuse again. if not, plug on light in at a time. You might have a bad headlight???? then unplug that one if nothing happens. Then plug the other one in. It could also be a bad taillight bulb. I have had bad tail light bulbs. Do all of them, one at a time.
SOURCE: Where is the oil drain plug on a 2003 bmw 325 xi?
At the bottom of the oil sump. some of them have a small square panel that needs to be removed and its under this.
SOURCE: How do you reset the Service light on 2006 BMW 325
Hi , to reset the service light you will need to insert the key and turn the ignition lights on but do not start the engine. you will see a push button on the lower left side of the instrument panel press and hold this until you have a triangle appear which then turns to the brake warning symbol , release the push button then press and hold the bc button in the indicator arm until reset appears , release and again press and hold the bc button until you have a moving clock symbol appear , release the bc button and wait for the display to change , once this has reset turn off the ignition and the service symbol should have reset . you may want to print these instructions before resetting , regards Mark.
SOURCE: is there a fuse for the license plate lights on a
The licence plate lamps are tied to your tail lamp fuse on most models. Might be a bad ground.
240 views
Usually answered in minutes!
×