This indicator light is used to display the working status of the automatic overspeed gear. When the indicator light is on, it means that the O/D gear is locked. At this time, the acceleration capacity is improved, but the fuel consumption increases.
If the indicator light is not on, the possible fault points include: gateway damage, ELV electronic steering lock damage, key damage, comfort CAN line failure, drive CAN line failure, anti-theft function failure, steering column control unit failure, instrument control unit failure, and There may be strong signal interference from the outside world. You need to go to a professional repair shop to repair your toyota highlander or buy a new car, such as toyota calya.
SOURCE: 06 Laredo - AC/Heat & Rear Defrost Dash Lights Not Operable
there is a fuse under the hood its a 10amp fuse... when you open then cover you will see 3 red 10amp fuses is the at bottom
SOURCE: Remote trunk release stopped working.
see if there is power at the solenoid with the button pushed inside the car. if so change the lock solenoid. best of luck
SOURCE: Air Condition
ac system is never leak proof. even on new cars. after a few years it needs recharging.,
SOURCE: Rear brake lights and turning
I'm checking into that same problem for a early 90's buick ( it's a GM also ) , I've checked the obvious ( bulbs, flasher,fuses,etc) all where fine. I assume your front turn signals work if you manually operate the turn signal switch or put on the hazard switch? The Buick's rear lights won't come on even with the hazard switch on. When you say one tail light has been out for some time, do you mean the brake/signal light or park/running lights? The Buick was like that with one side out for a while ( brake/signal light) but both the rear park/running lights work. Now, I've narrowed the problem down to the turn signal switch. I'd bet money on it. I just have to dig out my steering wheel puller, bite the bullet and get 'er done. You should be carefull if you're attempting that repair yourself ( AIRBAG ), use a manual. ( You could do a quick test by trying the turn signal while you pull the bottom of the arm toward you,move some of the wiring in the column near the arm,etc. I did and the signals started working. Could be the switch,dirt or a broken/loose wire. there's a lot of wiring going through the column and a lot of movement ( turn signal,high beam,cruise, then add tilt) Hope this helped.
SOURCE: 99 chevy dash,parking running lights don't work!
did you replace the dimmer switch on the dash by the headlight switch
289 views
Usually answered in minutes!
×