Cars & Trucks Logo

Related Topics:

carol Paulsen Posted on Oct 08, 2018

Is there an icon that I need to tap on to activate parking assist on my GLC300 .

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I just bought a 2015 Genesis Coupe. How do I activate the Park Assist Feature? It doesn't seem to be working.

Read your Manuel. You can turn parking assist on and off. On some cars you have to scroll through the radio menu to find it . On others it is on the digital screen scroll stalk.
0helpful
1answer

Why does the 4wd button blink on a 2004 tundra?

Four wheel drive actuator may me at fault, try park the truck on a slick surface like wet grass, set it in neutral and activate 4hi and 4lo back to 2wd a few times, if doesn't help try tapping on motor actuator located on transfer case while someone activates selector, park surface must be as level as possible, a good tip is to activate your four wheel drive once every few months to avoid it freezing up.If nothing helps then it needs to be diagnos by a tech. good luck
0helpful
1answer

RPA active message. what does it mean?

Rear parking assist, the beep lets you know how close you are.
4helpful
1answer

I keep getting check park asistant my dash. How do i check the problem.

the check park assist is a switch on the brake pedal which activates the selector (gear shift) to move from park and vice-versa when brakes are applied. this switch could be loose or need adj
5helpful
1answer

Dash lights show car with back lights on what does this mean

Hello. Welcome to FixYa. Please allow me to assist you.

That icon is telling you that one of your taillamp or your brake light bulbs is burnt out. All you need to do is turn on the parking lights, and check to see if they all work. Then, have someone press the brakes whilst you observe the operation of the brake lights; also note to see if the brake light in the back window is working. Once you replace the burnt out bulb, the icon will reset itself, and will stay out.

Thanks for choosing FixYa for assistance today. If my advice helps you out, a 4-thumb rating would be greatly appreciated.
2helpful
2answers

Windshield washer fluid does not respond when activated

does electric pump on bottom of washer reservoir run when activated? if it does try blowing through tubes to it and to bonnet squirters.if these squirters are blocked,just use a pin to clear. if motor is silent try tapping it with something while someone activates it.it may be just frozen from lack of use. can check fuse but these usually only blow if electric motor on pump shorts out or seizes
2helpful
2answers

My (brake) light turns on in the dash and wont go off what can it be?...

This light can be caused by your parking being on. If not, it's most likely caused by low brake fluid. Check the fluid level under the hood and fill it up if needed. If that doesn't get rid of the light, you should have it towed to a dealer and don't drive as your brakes may fail at any moment without notice
1helpful
2answers

The led panel over the rearview mirror says that the Parking Assist is disabled but I cannot enable it following the instructions in the owners manual and it doesn't reset when the ignition is turned off....

I had this situation too, exactly. Everybody told me it was probably a rear bumper sensor gone bad, but at least in my case, no such luck. It was the Park Assist Module, basically the control computer for the whole system. A new one fixed it, but was about $300.
Not finding what you are looking for?

55 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...