Trip computer on my e46 does not work. when i bought the car it only displayed the temp, but when i took out the instrument panel and put it back in it now only displays the time. i checked the fuses and they are fine.
any help would be much appreciated?
thanks
SOURCE: 1998plymouth grand voyager- the front
You can check this out and see if it helps.
[email protected]
http://www.davintosh.com/2007/09/15/fixin-the-dashboard/
SOURCE: NUMBER PLATE LIGHTS NOT WORKING
take the bulb back out and clean inside the bulb holder, there may be some corrosion or other debris in there
SOURCE: Dashboard light and instruments not working
bulbs behind the gauge cluster most likely need to be replaced....
SOURCE: instrument cluster panel
Not a Fuse. There are Small Bulbs on the Back of the Guage Cluster that Burn out Occassionally. You will need to Disassemle the Dash and Remove the Guage Cluster to get to these Mini-Bulbs for Replacement. Please Rate my Solution, I need all the Help that I can Get! Thanks!
SOURCE: 2000 dodge neon won't start.
look everyone !!! i am not the only one who has this problem , but I
found the answer on my own.... iI hope this can help others . If you
have to replace a neon engine you must do these thing if you want it to
start.
<br>
Lower vehicle and perform camshaft and
crankshaft timing relearn procedure as follows:
² Connect the DRB scan tool to the data link
(diagnostic) connector. This connector is located in
the passenger compartment; at the lower edge of
instrument panel; near the steering column.
² Turn the ignition switch on and access the “miscellaneous”
screen.
² Select “re-learn cam/crank” option and follow
directions on DRB screen
Most people don't have access to this scanner <but it must be done> I used a snap-on cost 3000 but have the reset feature
Thanks you all for your help.
291 views
Usually answered in minutes!
×