I can see "J19LN" written on the end of the spark plug.
For Australia, find your model
https://www.rover.com.au/manuals.html
Spark Plug Gap .030 in (,76 mm)
Spark Plug Torque 180 lb-in (20 Nm)
https://www.sparkplug-crossreference.com
J19LM 21mm hex wrench
It is a 13/16 deep socket
Use a 5/8 deep socket spark plug socket preferred. Turn counter clockwise to remove. Just dont drop dirt in cyl or tighten more than 1/4 turn.
Most plug sizes are either 5/8 or 7/8. Don't over tighten the new one. Snug is good.
SOURCE: 1997 escort 1.8 gti zetec
it should be a 5/8th inch (us) assuming that this is a AGSP32C plug that cross ref to a 2756 NGK plug. Let me know [email protected]
SOURCE: Land Rover Discovery 2 Spark plug diagram needed.
This is your best choice.Here is a diagram attached.
SOURCE: SPARK PLUG CHANGE 98 volkswagen jetta gl
you will need the tool made for pulling the boots off but then all you need is a 3/8 rachet ,about a foot long extension, a universal , then probably 13/16 spark plug socket <could be peanut plug depending on the manifaturer of the plugs> I recomend using bosch or ngk plugs. intake removeal is not needed ....will clear all plugs with intake on but may need to unplug a couple injectors for clearance but don't forget to plug them back in
SOURCE: How do I change spark plugs on a 2001 Mazda Protege es model ?
that rubber ring is the bottom of the spark plug wire boot you will have to get this out before you can get the plug out. no special tools needed except socket long extension and ratchet. just remove the wires or coil over ignition coils however your car is setup, install socket and remove the old plug.
Testimonial: "Thank you for the info. Just one question. Can I dig the ring out with a screwdriver? "
SOURCE: 2008 dodge avenger spark plug location and socket size.
125 views
Usually answered in minutes!
×