What is the capacity of automatic transaxle fluid for Hyundai Santa Fe 2004

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

SOURCE: how to change spark plugs on hyundai 2004 2.4L

Remove the plastic cover that goes over the engine (the one with the Hyundai logo).
At this point, you will see the cables that goe to each fo the spark plugs.
Noting their position, remove them.
The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones.

SOURCE: WHICH POWER STEERING FLUID TO USE IN 2003 HYUNDAI

You must use the fluid type stipulated by the vehicle manufacturer as there are different specs for different vehicles.

The specification for power steering fluid should be listed in your owners manual. You can then purchase a quality brand at that spec.

If you don't have the owners manual ring the dealer service department or parts department and they will give you the correct specification for your particular model.

Marvin

• 85242 Answers
• Posted on May 22, 2009

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

SOURCE: How to change fuel filter in 2004 Hyundai Santa Fe

Hi,

Please follow the steps to change the fuel filter. You would need to remove the left rear seat (four 14mm bolts). I think you'll need to finish cutting through the tabs on the carpet to be able to lift up the carpet. Then remove the access cover. You can then remove the fuel pump from the top of the tank.

Thank you for contacting Fixya.com