Removing head restraints from a 2004 chrysler sebring

SOURCE: chrysler 2004 sebring manual

remove the hidden screws be hind mini covers, start from the bottom of panel with panel tool and pry the plastic retainers away from the door plate and remove the wire connectors form switches and replace the handle, reverse the order, GOOD LUCK, RDJRP

SOURCE: 2004 chrysler sebring oil leak

The solenoid blocks are known to leak. You will need to access this under the hood. The cooling lines well need removed from the trans, disconnect the input speed sensor, and remove it using a 1" deepwell socket. Remove the plug on the solenoid block, using an 8mm socket. You will see 3 tenmm bolts on the top of the Sol block. Remove these bolts, then gently pry the sol block off the trans. Using a scraper, remove all old gasket material from the trans case, be careful not to damage it, then thoroughly clean the mounting surface. Install the new Sol Block, with a new gasket, and torque to factory specs, re-install the input speed sensor (torque to spec), install the cooling lines, and reconnect the Sol Block 8mm screw, be sure to TORQUE all to factory spec, failure to do this could result in you damaging the new Sol block, or trans.Make sure to check the fluid level after the repair is complete, and you should have the TCM reset as well. It is fairly labor intensive, and for a first-timer, it will probably take you about 2-3 hrs to do this, provided you have the proper tools. Good luck.

SOURCE: 2004 chrysler sebring grinding noise

Check CV Joints and AXEL BEARINGS This is Common

SOURCE: oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan

Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!