What alarm ? content theft alarm ? No fuse
When armed, the content theft deterrent (CTD) system is designed to deter vehicle content theft by pulsing the horns and exterior lamps for approximately 30 seconds when an unauthorized vehicle entry is detected. However, the CTD system does not affect engine starting.
An unauthorized entry can be any of the following with the CTD system armed:
• When any door is opened without first being unlocked using the keyless entry transmitter
• After a battery reconnect, if the battery was disconnected with the CTD system armed
The components of the CTD system are:
• Body Control Module (BCM)
• Security indicator
• Door ajar switches
• Liftgate ajar switch
Is this the alarm your talking about ?
SOURCE: How do I replace a lowbeam headlight bulb on a 2008 GMC Acadia
You will have to go through your mud guards. Remove your tire, and look inside your wheel well, you will see two part mud guard, front half and back half. Just remove the 7 screws from the front half, 5 on the wheel well itself, and two on the bottom, retaining screw to the bumper, now depending on which side you're looking at anywhere from 5-7 plastic pop-its. Use a flat tip screw driver to loosen the pins up, then remove the pop-it studs. There are two on the bottom front that connect to the vehicle frame. Once this is removed, you can access your headlight assemby to replace both bulbs. Note, you will have to do this to replace your fog light bulb should it go out as well.
SOURCE: 2008 gmc acadia low beam light bulb changing
how do you change the low beam light bulb on the 2008 gmc acadia
SOURCE: How do you change the halogen bulb in the
under the hood there will be a large, plastic weather cover to unscew by hand, remove the 3 pin connecting plug, there will be a spring loaded clip holding in the globe, depress the looped end and divert it over to one side thsi will release the globe, assembly is in reverse, be careful as not to touch the end og the globe, as the oil on your fingers are detremental to its operation. No special tools required to do this. Good luck
SOURCE: how to change your headlamp in a 2008 gmc acadia
Open the hood and look in the area behind the headlight itself. You will see the wires running in to the light through a collar. Turn the collar counter clockwise and remove the assembly. Remove the bulb and plug in the new bulb and reverse the process to replace.
Testimonial: "great info"
834 views
Usually answered in minutes!
×