All worke fine when car is not running
SOURCE: gauges go out, car runs fine, radio works, abs light on turn signal works
this is a body control module (BCM) fault, replace it..
SOURCE: turn signals dont work bulbs/fuses are good.
check to see if the emergency flashers work if they do its its either a wiring problem, bulb, or socket the bulb fits in. if it does not work than the flasher is the problem. it is located underdash on driver side in the kick panel( to left of the brake pedal) it is a blue or grey sguare relay looking plug. if it is factory flasher it will say flasher with the part # on it. it should also say toyota on it. good luck
SOURCE: '87 Cherokee no horn, turn signals, brake lights, wipers, blower
Pull the fuses and check the socket for power on the things that don't work. If there is no power at the fuse box there is a good change the stater igintion switch is toast. it is located on top of the steering colunm under the dash.usally less then 20 bucks All that you mentioned get power from this switch that goes to the fuse panel when you turn the key on
SOURCE: car wont start radio,wipers,gauges,turn signals dont work
Check the battery cable ends to be sure they are tight and wont twist, I had this happen on my 96 grand caravan two years ago.
SOURCE: 2004 monte carlo. turn signals dont work. the
try pressing the hazards on and off if they still don,t work replace the flasher unit. it is built into the hazard switch( all one unit ) change this and all will be good.
173 views
Usually answered in minutes!
×