What size starter bolt for 2002 Chrysler 300M

Marvin

• 85242 Answers
• Posted on Apr 22, 2009

SOURCE: need location of coolant sensor on 2002 chrysler 300m

near the thermostat I think, look for this part.

SOURCE: remove starter from chrysler 300m

there is a bracket bolted to the end of starter to block

SOURCE: replace oil pan gasket 2002 chrysler 300m

The owner of the car should be able to locate and replace oil pan gasket .prepare the equipment to be used .Drain the oil from the oil pan ,spill it to an empty big can that can carry the oil from the oil pan.Then twist the bolts that connect the oil pan to the engine.After removing the bolts then you have take the old gasket off to the oil pan.After taking off the old gasket then you have to replace it with the new oil pan gasket.then return the oil pan with the new gasket. twist the bolt back until the oil pan that connect the oil pan with the engine.And return the drain plug twist until it will not spill.

SOURCE: trying to find location of blower on 2002 chrysler

under the glove box,pull out plastic push pin holding plastic duct work and remove duct piece,three screws holding blower motor cover,remove them,then disconnect blower motor wires at connector,remove three screws holding motor up in place.
watch the mice don't fall on you!

SOURCE: What will it cost to replace the starter on a

parts and labor you will probably be looking at around $300 depending on what part of the country you live in and where you take it for repair.