How to replace starter on 1998 Mercury villager
Https://www.youtube.com/watch?v=tt3MsLREgiThis video will help you.
SOURCE: Mercury Villager headlight assembly diagaram for removal
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
SOURCE: where is a knock sensor for 1998 Mercury Villager located?
Here is a image of it's location, I hope it helps.
SOURCE: 95 Mercury Villager will not start
check/replace the starter relay switch in the relay box under the hood. The relay box is located on the front right of the engine compartment. easy fix, inexpensive part if that is the problem.
SOURCE: Code reader knock sensor where is it located
According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.
SOURCE: Have a 1995 Mercury Villager that wont start have
I assume it won't crank. Are you getting power to the small terminal to the starter when someone turns the key? Can you jump power to it and get it to crank? It could be a bad neutral safety switch.
Testimonial: "thanks so much this helped me find the problem when I was checking the neutral safety switch I found a wire that was off which went to the switch."
174 views
Usually answered in minutes!
×