Visit the on-line site, known as
https://big-manuals.com/products/ford-f150-1980-1995-workshop-service-manual
they have the best repair solutions
SOURCE: 1995 Ford Explorer power window motor removal
You have to drill a hole in the sheet metal after you pull off the door panel. There is a dimple where the hole should be drilled. Make sure the hole you drill is big enough to fit the socket. I don't know why ford deigned it like this.
SOURCE: 1989 Ford F150 power window
you have to disconnect the negative side of the battery so you won't kill it then remove the door panel look for hidden screws behind the arm rest and behind what looks like little doors that you have to use a screw driver to open once that is removed you will find a plastic sheet just cut and peel this back (you can use duct tape to replace it when you are done) also put on gloves because inside the doors there is sharp edges, you then can see the motor and you will need to break off the rivets but you can put the new one on with just a small bolt and nut and use lock tight
SOURCE: how to remove inside door panal to replace window motor?
Remove the window switch bezel. It has a snap clip in the front just pry the front up with a pick or small screw driver the pull it forward and disconnect. Remove the plastic covers from the ends of the pull strap and remove the 2 screws.Then locate the 2 screws at the bottom of the door panel and remove.Then pull out on bottom of door panel and work your way up to release the plastic push pins.
SOURCE: want to remove driver side door panel to gain access to power window motor
first remove the tweeter speker if equipped this comes off easily by gently prying from behind, then remove the small panel behind pull handle you"ll find a screw behind it\remove that,the next part is a little tricky the door grip needs to come off to achieve this place a small flat screwdriver at the top of the handle and pry forward the turn handle counterclockwise and this will release it from the clips you"ll then find 2 screws one at the top other at the bottom of door grip remove those and then gently pry from the bottom of the door panel to release the retaining clips thats it
SOURCE: how to replace the power window switch on a 2005
just a standard screwdriver...
on the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge.
169 views
Usually answered in minutes!
×