We have a Dodge Durango 2012 pulling a Coachman Freedom Express 2014. The Prodigy flashes 00 and .c. All the time and the trailer brakes do not seem to be working. Car brakes smell hot when we stop. Any suggestions?
If your Prodigy P2 brake controller is flashing 00 and .c, it could indicate an error with the brake controller's connection to the trailer or the brake controller itself. Here are a few things to check:
If you have checked these items and are still experiencing issues, it may be necessary to take your vehicle and trailer to a certified mechanic or dealership for further diagnosis and repair. The hot brake smell from the car brakes could indicate that the trailer brakes are not functioning correctly and that the tow vehicle's brakes are doing most of the work, which can lead to overheating and brake fade.
SOURCE: All power windows stopped working on dodge Durango
check relay switch for power windows should be under hood with other relays
SOURCE: 1999 Dodge Durango. Speedometer not working.
We had the same problem. The dealership wanted to do a 2,000 major overhaul of the rear axle. I found out there is a speed sensor that is easily replaced (it happened a few years ago but I remember the part being pretty inexpensive). Hope this helps.
SOURCE: my 2000 dodge durango turn signal lights stop working.
A Mechanic told me my switch was broken, but the switch was working fine, the lights just stopped flashing. After some research and consulting with a male friend who knows more about this than I, we discovered it was only the turn signal flasher -- a $16.00 part. On the 2000 model, it's located under the dash, on a separate fuse panel I didn't even know was there. It's to the left of the steering column and right behind the main fuse box, but you can only get to it by going up under the dash. The green one is a little hard to get to, but that's the one for the hazard lights. Its easy to see with a good shop light. It's 1" by 1" ish. The turn signal flasher is below the green one. It's black and a little smaller, and much easier to get to. You simply unplug it and plug the new one in. Voila! There are other fuses on this panel -- I'm not sure what they go to, but I intend to find out so I don't waste money replacing parts I don't need to.
SOURCE: durango trailer wiring left turn signal doesn't
I lost all of my trailer lights. Turns out the wires in the harness were corroded out by the gas tank. Dealer said it was a common problem
130 views
Usually answered in minutes!
×