SOURCE: How do I disable the seatbelt chime on an '89 VW?
look at the buckle and see if there are two wires going into it. if there is cut those and wire them together. or you can try and follow those wires back until you hit a fuze or something. alot of times though that fuse is shared with something else silly like a dome light or radio though
SOURCE: Is there a fuse to pull to stop the seatbelt chime?
Pulling the fuse is not an option.Check your owners manual for instructions on how to shut it off..
SOURCE: Drivers side seatbelt connected When truck is
sensor in the seat belt bukle needs to be replaced
SOURCE: Is there a passcode or sequence to disable the
yes there is, it sounds retarded, but
-Turn car keys to power up but not start the car.
-Wait till the seatbelt light goes out (about 8-10 seconds)
-Put the seat belt buckle on and off 3 times
-Turn your park lights on once
-Put your buckle on and off 7-10 times till the seatbelt light flashes rapidly
-Once the seatbelt light stops flashing
-Put the seatbelt on
-Start up your vehicle
Like i said, i know it sounds stupid, but it worked for me! Good luck!
SOURCE: 2005 pontiac sv6 door alarm
On my '07 Montana SV6 was the same problem, I've fix it by moving up to 3 mm. contact plate at the body frame of the rihgt sliding door. If you check the spots on the plate where pins from the door comes to this plate, you will see that they contacting not in a middle. There are two ways to fix: move down pin unit in the door or move up contact plate on frame. For me second way was better. It's manufacture mistake comes sinse 2005 and on right door only.
450 views
Usually answered in minutes!
×