How do I clear the code?
The follow link may help:
http://productload.johnsonfit.com/inc/uploaded_media/8bed1bc924000d07ecaa6d43edec18db/troubleshooting_guide/87fc08ffe3e0caa8a9d3a1b15d59e71d.pdf
The E6 error code means that the signal from the elevation is lost.
E6 Solution:
1. Check the elevation plug connection at the lower board.
2. Check large data cable connection at the lower and upper boards.
3. Calibrate (See engineering mode for specific treadmill)
4. Test/change large data cable (use large data cable information provided in the data cable portion of this Guide).
5. Replace elevation motor
See page 17 on the following link to enter into engineering mode. ENG4 is Auto-Calibration
https://data2.manualslib.com/pdf2/49/4851/485073-vision_fitness/t970hrt_service__manual.pdf?a70bdaa881cbfa6431ecf6d2abc581e6&take=binary
415 views
Usually answered in minutes!
×