2012jeep grand Cherokee 5.7 liter hemi
Totally Integrated Power Module. It’s a fuse box with a computer inside it. If you replace yours, it must be programmed for it to work. Usually a dealer or a high end shop will have to program it.
Totally integrated power module - electronic control module built into the under hood power distribution center .
Defective TIPM Is Causing Dangerous Power Problems in Chrysler Vehicles
SOURCE: 2000 jeep grand cherokee 4.0 liter engine timing belt replacement
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
SOURCE: 2005 Jeep Grand Cherokee (HEMI) Service Electric Brake System
Problem is a faulty Steering Angle Sensor (part of Steering Module) located in steering column ...replacement part $600.00.
SOURCE: 05 grand cherokee with hemi won;t start.
Does it turn over? If not, try disconnecting the battery and reconnecting it. This has worked for my Jeep before.
SOURCE: 2005 Grand Cherokee grinding
The Wheel Bearing(s) need to be replaced. They should be bolt-on assembly and are bolted from the back of the steering knuckle. It is easy to remove and replace. Buy your bearing assembly(ies) from an auto parts store versus the dealer to save you a lot of money.
SOURCE: Knocking motor sounds 2005 5.7 Hemi Grand Cherokee
knocking? or pecking? check the knock sensor but if it is a hard knock sorry to say but you have a bad crank shaft and worn bearings
179 views
Usually answered in minutes!
×