Hi, Do you have the torque specifications for a Toyota Camry 1997 3.0P GLX Sedan 4A STARTER MOTOR bolt to engine please

SOURCE: need torque settings for 1985 4A corolla cylinder head

hey, torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:

9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10

SOURCE: window motor fuse location on 92 toyota camry le

look behind the money chance container l side lower dash

g gl

joecoolvette

• 5660 Answers
• Posted on Jul 25, 2009

SOURCE: need the cylinder head torque settings on a toyota

Tighten in several passes to 44 foot pounds.

I just wanted to add. Since this is an aluminum cylinder head, I hope you loosened the head in the loosening torque pattern. The pattern opposite of the torque tightening pattern. If not, you stand the chance of warping the head.

Again, since it's an aluminum head, it needs to be checked for flatness. Most aluminum heads need to be surfaced before re-installing.

Tightening torque pattern is as follows:

1.The Drivers side of the engine is the Left side.
From the Front going towards the back; the bolts are numbered 10, 6, 1, 3, and 7.
From the Front going towards the back on the Passenger side; the bolts are numbered 8, 4, 2, 5, and 9.

The Exhaust and Intake Camshaft Bearing Cap bolts go to 9 foot pounds. Tighten gradually. One bolt to the other with so many foot pounds, work back, and forth up to 9lbs.

Camshaft Timing Pulley bolts go to 43 foot pounds. (In a tightening sequence, and gradually)

SOURCE: HOW TO SET TIMING ON 96 TOYOTA CAMRY 2200 MOTOR

Click on the following free direct Link. It has the Timing: Pulley, Belt and Mark Diagrams for your 1996 Toyota Camry. Plus additional Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1996/make/toyota/model/camry/1996_toyota_camry_timing_belt_diagram_marks.htm

Geoffrey White

• 3965 Answers
• Posted on Nov 18, 2011

SOURCE: need torque specification for rod and crank shaft bearings on 1996 Toyota Camry 2.2 L

Main bearing cap bolts are 58 Nm or 43 ft-lb. The sequence is like this

7 3 1 5 9

8 4 2 6 10

Con rod cap nuts are 24 Nm or 18 ft lb, then, an additional 1/4 turn.

These figures are with an oil film on the parts, not dry, and should be reached in three steps right round, not all at once.