SOURCE: holden barina 2003
it means its due for service. If u wanna get rid of it without servicing the vehicle then as you start the car simultaneously push the ODOMETER reset button on the dash and it will wipe it. This will however just delay the point your car needs servicing.
SOURCE: changing a fuel pump on a 1991 holden barina
The Fuel Pump is Inside the Fuel Tank. You will need to Trop the Fuel tank for this. Not an Easy Job by any Means.
SOURCE: holden barina 94 model speedmeter not working how
There should be a cable that runs from the back of your speedometer to the transmission. If you look on the engines side of the firewall you should be able to track it....it is one of very few cables that run into the transmission. NOTE: its a little thicker than most. At the transmission there will be a fastener of some sort holding it in. Unscrew it and check the end of the cable. If all seems well try attaching a drill to that end and have a buddy look at the gage to see if it shows speed when the drill is running ...if not then its either broken in the middle somewhere or came unhooked from behind the guage....if it does show speed then it was either not seated correctly to the transmission or the plastic tip (looks like plastic gear) on the transmission side of the cable it worn down too far. That tip is interchangeable for if you get bigger/smaller tires.
SOURCE: holden barina left hand sideblinkers not working
check the turn signal relay that usually goes before the fuse
SOURCE: Holden Barina Swing 1998 autom. losing power, the inter cooler is changed the problem still the same
try this; there is a crank angle sensor that sit under the car behind the harmonic balancer. It's like a black round plug about 10 cm long. Change that and I'm sure things will run good again. A lot of people don't know about this, and if you are unsure of what it looks like, ask your mechanic or parts supplier to show you one.
300 views
Usually answered in minutes!
×